From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Mon, 5 Aug 2002 15:27:07 +1000 From: David Gibson To: linuxppc-embedded@lists.linuxppc.org Subject: Re: CS_BAD_VCC Error during Card Configaration. Message-ID: <20020805052707.GU5012@zax> References: <20020805043039.4380.qmail@webmail6.rediffmail.com> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii In-Reply-To: <20020805043039.4380.qmail@webmail6.rediffmail.com> Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: On Mon, Aug 05, 2002 at 04:30:39AM -0000, Narendra wrote: > > Hi. > > I am involved in porting WLAN driver to Embedded Planet RPX-LITE > board. > > I am using HHL - 2,4,2 and Pcmcia-cs (3.1.24). When i insert > D-Link DWL 350 prism2 card (intersil) my driver is invoked by > cardmgr. > > But as i found through debug message, socket is configured for > 5volts and the CIS read from my card wants 3.3V. So my Config() > routine is failing since there is a mismatch in configured Vcc and > Requested Vcc. and Kernel is crashing. > > Where i need to do modification to configure EP socket for 3.3v? > > Should i need to make any modification in m8xx_pcmcia.c? > > I didn`t come across this problem when i tested my driver in > Compaq Armada notebook. > > I am struck at this point. All inputs are welcome. Which wireless driver are you using? -- David Gibson | For every complex problem there is a david@gibson.dropbear.id.au | solution which is simple, neat and | wrong. http://www.ozlabs.org/people/dgibson ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/