From mboxrd@z Thu Jan 1 00:00:00 1970 To: "Jack Liu" Cc: "linuxppc-embedded@lists.linuxppc.org" Subject: Re: Sandpoint problems From: Wolfgang Denk Mime-version: 1.0 Content-type: text/plain; charset=ISO-8859-1 In-reply-to: Your message of "Mon, 16 Feb 2004 08:51:42 +0800." <200402160051.i1G0pKqA003808@ms.usish.com> Date: Mon, 16 Feb 2004 10:35:14 +0100 Message-Id: <20040216093519.B09DEC1096@atlas.denx.de> Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: In message <200402160051.i1G0pKqA003808@ms.usish.com> you wrote: > > I am planning to use U-Boot to replace DINK13 shipped in Sandpoint > platform. I got a sucessful compilation by: Make Sandpoint8245_config, > Make all . Then I Burn u_boot.src in the Boot ROM. IT CAN'T BOOT. I used > all default setting in the PrPMC8245 and Sandpoint board. I didn't know > the reason. Anybody knows? First, this is off topic on the linuxppc-embedded list. Please send U-Boot related questions to the u-boot-users list. Thanks. What exactly did you do? "I Burn u_boot.src"? There is no file u_boot.src. Do you mean u_boot.srec? Note that this is a S-Record file - are you sure you need to use the S-record file? Where exactly in flash did you program it? How did you verify that the flash programming worked? And what exactly do you mean by "it can't boot"? (An why are you shouting?) Is the board completely dead? Is there Some output? Which? Does U-Boot run, but fails to boot Linux? Or what? Best regards, Wolfgang Denk -- See us @ Embedded World, Nuremberg, Feb 17 - 19, Hall 12.0 Booth 440 Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de After Goliath's defeat, giants ceased to command respect. - Freeman Dyson ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/