From mboxrd@z Thu Jan 1 00:00:00 1970 Message-Id: <200405181550.AYL88709@sentry.ucr.edu> From: "Steve Kaiser" To: Subject: MPC5200 LEDs Date: Tue, 18 May 2004 08:50:43 -0700 MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: Before I plow into it, I ask for your advice. What is the best way to turn on/off the status LEDs on the Motorola Lite5200 ("IceCube") board? Although experienced with embedded micros & DSPs in general, I am a newbie to Linux and the MPC5200. Thanks to Wolfgang for the most excellent U-Boot and ELDK. With these tools, I have compiled a 2.4.25 kernel and have it running from either RAM or Flash in my 5200 IceCube. I can insmod a simple "hello world" module on my target. That's where I'm at. I figure the next exciting step is to turn LEDs on & off. Right? What's the best/correct way in the Linux tradition? Any tips are welcome. Steve Kaiser Chemistry Electronics Shop Univ of Calif - Riverside ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/