From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from mailout04.sul.t-online.com (mailout04.sul.t-online.com [194.25.134.18]) by ozlabs.org (Postfix) with ESMTP id 8C84267A6C for ; Thu, 17 Mar 2005 10:08:58 +1100 (EST) To: "veikko romppainen" From: Wolfgang Denk Mime-version: 1.0 Content-type: text/plain; charset=ISO-8859-1 In-reply-to: Your message of "Wed, 16 Mar 2005 23:22:25 +0200." Date: Thu, 17 Mar 2005 00:08:42 +0100 Sender: wd@denx.de Message-Id: <20050316230847.8D0B1C1510@atlas.denx.de> Cc: linuxppc-embedded@ozlabs.org Subject: Re: porting linux & u-boot on Mdp Pro 8xx board List-Id: Linux on Embedded PowerPC Developers Mail List List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , In message you wrote: > > I have currently running wxWorks on Mdp Pro 823 board. Now i'm trying port > Linux on it. Firstable i have to get u-boot working on it. I hope someone > has done this. Probably not. At least I don't know of any port of U-boot for this board. BUT: this is off topic here. Please post U-Boot related questions on the U-Boot mailing list instead. > Is there working configuration from u-boot to this board? > I have modified QS823 conf, because it looks quite similar. Similar is not good enough. > Can I use VisionIce 2 and SingleStep to flash u-boot? Probably, if you know how to use these tools. Sorry, I'm afraid there is little help for these on tyhe U-Boot list. > We dont't have BDI in our school, shame. I flashed u-boot by using Ice > starting at 0xfff00000. It seemed that it went correct place but nothing > happened when i started my board. Is this the correct address for your board? Did you use the correct terminal baudrate? > I suppose that I can't debug it with Ice and SingleStep. You should be able to. If not, return the tools to the vendor and get your money back. > Do i have to flash more than just u-boot.bin in right address? No. > (Environment?) No. If the environment is invalid (bad CRC checksum), then a compiled-in default environment will be used. > Do i need some reg files or prj files? Dunno. > I would appreciate if someone could help me with these addresses and > configs. > > Board specs: > MPC 823 66 Mhz > 4Mb flash > 128 Mb RAM > 512 K SRAM > 8 K eeprom Sorry, you need a lot more information about the hardware to give any usable help - and then it requires a non-negligible amount of work to come up with the right config data. Don't expect too much from a mailing list. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de Don't tell me how hard you work. Tell me how much you get done. - James J. Ling