* Re: [PATCH] ppc32: Add usb support to IBM stb04xxx platforms
2005-08-09 19:03 ` Eugene Surovegin
@ 2005-08-09 19:23 ` Dale Farnsworth
0 siblings, 0 replies; 2+ messages in thread
From: Dale Farnsworth @ 2005-08-09 19:23 UTC (permalink / raw)
To: Dale Farnsworth, linuxppc-embedded
On Tue, Aug 09, 2005 at 12:03:19PM -0700, Eugene Surovegin wrote:
> On Tue, Aug 09, 2005 at 11:53:27AM -0700, Dale Farnsworth wrote:
> [snip]
>
> > Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
> > ===================================================================
> > --- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/redwood5.c
> > +++ linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
> > @@ -52,8 +52,18 @@
> > void __init
> > redwood5_setup_arch(void)
> > {
> > + u32 mask;
> > +
> > ppc4xx_setup_arch();
> >
> > + /*
> > + * Set up USB interrupt as positive polarity and level-sensitive.
> > + * Firmware should do this, but apparently does not.
> > + */
> > + mask = 1 << (31 - USB0_IRQ);
> > + mtdcr(DCRN_UIC_PR(UIC0), mfdcr(DCRN_UIC_PR(UIC0)) | mask);
> > + mtdcr(DCRN_UIC_TR(UIC0), mfdcr(DCRN_UIC_TR(UIC0)) & ~mask);
> > +
>
> Please, DO NOT DO THIS.
>
> There is a way to configure UIC settings without messing with UIC
> registers directly. Refer to asm-ppc/ppc4xx_pic.h and other 4xx board
> ports for more information.
>
> Eugene
Deja vu all over again, eh Eugene? I re-submitted the wrong old patch.
Correct (I hope) patch follows.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.c
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/ibmstb4.c
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.c
@@ -11,6 +11,7 @@
#include <linux/init.h>
#include <asm/ocp.h>
+#include <asm/ppc4xx_pic.h>
#include <platforms/4xx/ibmstb4.h>
static struct ocp_func_iic_data ibmstb4_iic0_def = {
@@ -72,12 +73,51 @@
.irq = IDE0_IRQ,
.pm = OCP_CPM_NA,
},
- { .vendor = OCP_VENDOR_IBM,
- .function = OCP_FUNC_USB,
- .paddr = USB0_BASE,
- .irq = USB0_IRQ,
- .pm = OCP_CPM_NA,
- },
{ .vendor = OCP_VENDOR_INVALID,
}
};
+
+/* Polarity and triggering settings for internal interrupt sources */
+struct ppc4xx_uic_settings ppc4xx_core_uic_cfg[] __initdata = {
+ { .polarity = 0x7fffff01,
+ .triggering = 0x00000000,
+ .ext_irq_mask = 0x0000007e, /* IRQ0 - IRQ5 */
+ }
+};
+
+static struct resource ohci_usb_resources[] = {
+ [0] = {
+ .start = USB0_BASE,
+ .end = USB0_BASE + USB0_SIZE - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = USB0_IRQ,
+ .end = USB0_IRQ,
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static u64 dma_mask = 0xffffffffULL;
+
+static struct platform_device ohci_usb_device = {
+ .name = "ppc-soc-ohci",
+ .id = 0,
+ .num_resources = ARRAY_SIZE(ohci_usb_resources),
+ .resource = ohci_usb_resources,
+ .dev = {
+ .dma_mask = &dma_mask,
+ .coherent_dma_mask = 0xffffffffULL,
+ }
+};
+
+static struct platform_device *ibmstb4_devs[] __initdata = {
+ &ohci_usb_device,
+};
+
+static int __init
+ibmstb4_platform_add_devices(void)
+{
+ return platform_add_devices(ibmstb4_devs, ARRAY_SIZE(ibmstb4_devs));
+}
+arch_initcall(ibmstb4_platform_add_devices);
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.h
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/ibmstb4.h
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.h
@@ -73,9 +73,9 @@
#define OPB0_BASE 0x40000000
#define GPIO0_BASE 0x40060000
+#define USB0_BASE 0x40010000
+#define USB0_SIZE 0xA0
#define USB0_IRQ 18
-#define USB0_BASE STB04xxx_MAP_IO_ADDR(0x40010000)
-#define USB0_EXTENT 4096
#define IIC_NUMS 2
#define UART_NUMS 3
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/redwood5.c
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
@@ -18,6 +18,19 @@
#include <linux/ioport.h>
#include <asm/io.h>
#include <asm/machdep.h>
+#include <asm/ppc4xx_pic.h>
+
+/*
+ * Define external IRQ senses and polarities.
+ */
+unsigned char ppc4xx_uic_ext_irq_cfg[] __initdata = {
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 0 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 1 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 2 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 3 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 4 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 5 */
+};
static struct resource smc91x_resources[] = {
[0] = {
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
^ permalink raw reply [flat|nested] 2+ messages in thread
* [PATCH] ppc32: Add usb support to IBM stb04xxx platforms
@ 2005-08-09 21:38 Matt Porter
0 siblings, 0 replies; 2+ messages in thread
From: Matt Porter @ 2005-08-09 21:38 UTC (permalink / raw)
To: akpm; +Cc: linuxppc-embedded
Support ochi-ppc-soc.c on IBM stb04xxx platforms
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Matt Porter <mporter@kernel.crashing.org>
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.c
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/ibmstb4.c
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.c
@@ -11,6 +11,7 @@
#include <linux/init.h>
#include <asm/ocp.h>
+#include <asm/ppc4xx_pic.h>
#include <platforms/4xx/ibmstb4.h>
static struct ocp_func_iic_data ibmstb4_iic0_def = {
@@ -72,12 +73,51 @@
.irq = IDE0_IRQ,
.pm = OCP_CPM_NA,
},
- { .vendor = OCP_VENDOR_IBM,
- .function = OCP_FUNC_USB,
- .paddr = USB0_BASE,
- .irq = USB0_IRQ,
- .pm = OCP_CPM_NA,
- },
{ .vendor = OCP_VENDOR_INVALID,
}
};
+
+/* Polarity and triggering settings for internal interrupt sources */
+struct ppc4xx_uic_settings ppc4xx_core_uic_cfg[] __initdata = {
+ { .polarity = 0x7fffff01,
+ .triggering = 0x00000000,
+ .ext_irq_mask = 0x0000007e, /* IRQ0 - IRQ5 */
+ }
+};
+
+static struct resource ohci_usb_resources[] = {
+ [0] = {
+ .start = USB0_BASE,
+ .end = USB0_BASE + USB0_SIZE - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = USB0_IRQ,
+ .end = USB0_IRQ,
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static u64 dma_mask = 0xffffffffULL;
+
+static struct platform_device ohci_usb_device = {
+ .name = "ppc-soc-ohci",
+ .id = 0,
+ .num_resources = ARRAY_SIZE(ohci_usb_resources),
+ .resource = ohci_usb_resources,
+ .dev = {
+ .dma_mask = &dma_mask,
+ .coherent_dma_mask = 0xffffffffULL,
+ }
+};
+
+static struct platform_device *ibmstb4_devs[] __initdata = {
+ &ohci_usb_device,
+};
+
+static int __init
+ibmstb4_platform_add_devices(void)
+{
+ return platform_add_devices(ibmstb4_devs, ARRAY_SIZE(ibmstb4_devs));
+}
+arch_initcall(ibmstb4_platform_add_devices);
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.h
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/ibmstb4.h
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/ibmstb4.h
@@ -73,9 +73,9 @@
#define OPB0_BASE 0x40000000
#define GPIO0_BASE 0x40060000
+#define USB0_BASE 0x40010000
+#define USB0_SIZE 0xA0
#define USB0_IRQ 18
-#define USB0_BASE STB04xxx_MAP_IO_ADDR(0x40010000)
-#define USB0_EXTENT 4096
#define IIC_NUMS 2
#define UART_NUMS 3
Index: linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
===================================================================
--- linux-2.5-usb-405.orig/arch/ppc/platforms/4xx/redwood5.c
+++ linux-2.5-usb-405/arch/ppc/platforms/4xx/redwood5.c
@@ -18,6 +18,19 @@
#include <linux/ioport.h>
#include <asm/io.h>
#include <asm/machdep.h>
+#include <asm/ppc4xx_pic.h>
+
+/*
+ * Define external IRQ senses and polarities.
+ */
+unsigned char ppc4xx_uic_ext_irq_cfg[] __initdata = {
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 0 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 1 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 2 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 3 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 4 */
+ (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE), /* Ext Int 5 */
+};
static struct resource smc91x_resources[] = {
[0] = {
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2005-08-09 21:38 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2005-08-09 21:38 [PATCH] ppc32: Add usb support to IBM stb04xxx platforms Matt Porter
-- strict thread matches above, loose matches on Subject: below --
2005-08-09 18:53 [PATH] " Dale Farnsworth
2005-08-09 19:03 ` Eugene Surovegin
2005-08-09 19:23 ` [PATCH] " Dale Farnsworth
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).