* how to make a PCI net card work on ICECUBE ?
@ 2005-09-29 3:56 ÏÄÓê
2005-09-29 7:58 ` Wolfgang Denk
0 siblings, 1 reply; 3+ messages in thread
From: ÏÄÓê @ 2005-09-29 3:56 UTC (permalink / raw)
To: wd; +Cc: linuxppc-embedded
Thanks for your help.
I found out that the ICECUBE board could tftpboot via the PCI netcard if wire net to the card, but the board could not mount NFS via the card.
So i set the environment ethact to i82559#0 and saveenv , but the board still could not mount NFS via the card.During the booting-up ,there was nothing about eth1 shown .
And i wired net to the FEC ethernet port,reset the board,found that the environment ethact was now FEC ETHERNET,so i set it again to i82559#0 and saveenv,booted up the kernel, there was nothing about eth1 shown , i tried ifconfig eth1 * up ,information were below:
bash-2.05b# ifconfig eth1 198.87.102.218 up
SIOCSIFADDR: No such device
eth1: unknown interface: No such device
eth1: unknown interface: No such device
where did i make mistakes ?
Best Regards
xiayu
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: how to make a PCI net card work on ICECUBE ?
2005-09-29 3:56 how to make a PCI net card work on ICECUBE ? ÏÄÓê
@ 2005-09-29 7:58 ` Wolfgang Denk
0 siblings, 0 replies; 3+ messages in thread
From: Wolfgang Denk @ 2005-09-29 7:58 UTC (permalink / raw)
To: xiay; +Cc: linuxppc-embedded
In message <200509291156.AA2359564@NARI-RELAYS.COM> you wrote:
>
> I found out that the ICECUBE board could tftpboot via the PCI netcard if wire net to the card, but the board could not mount NFS via the card.
>
> So i set the environment ethact to i82559#0 and saveenv , but the board still could not mount NFS via the card.During the booting-up ,there was nothing about eth1 shown .
...
> bash-2.05b# ifconfig eth1 198.87.102.218 up
> SIOCSIFADDR: No such device
> eth1: unknown interface: No such device
> eth1: unknown interface: No such device
>
> where did i make mistakes ?
I guess you forgot to configure the correct driver for your network
card into your Linux kernel.
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Old programmers never die, they just branch to a new address.
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: how to make a PCI net card work on ICECUBE ?
@ 2005-09-29 9:24 debora liu
0 siblings, 0 replies; 3+ messages in thread
From: debora liu @ 2005-09-29 9:24 UTC (permalink / raw)
To: linuxppc-embedde; +Cc: xiay@nari-relays.com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^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2005-09-29 9:24 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2005-09-29 3:56 how to make a PCI net card work on ICECUBE ? ÏÄÓê
2005-09-29 7:58 ` Wolfgang Denk
-- strict thread matches above, loose matches on Subject: below --
2005-09-29 9:24 debora liu
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).