Re: Ramdisk of ELDK 3.1.1 not run

[Wolfgang Denk <wd@denx.de>]

In message <20061106142604.14632.qmail@web33012.mail.mud.yahoo.com> you wrote:
>
> I had used kernel of ELDK 3.1.1 and Ramdisk of ELDK 4.0 on board MPC8xxL .It run ok but I see it will meet trouble :D

Yes, this is to be expected. The ELDK 4.0 ramdisk built  with  a  2.6
kernel in mind.

> When I use kernel and Ramdisk of ELDK 3.1.1 for MPC8xxL (I only rebuild Kernel use oldconfig and use uRamdisk in source (not rebuild )) but I receive error
...
> Kernel command line: 

You don't pass any boot arguments here.

> What I miss?May i correct it 

You obviously missed to read the documentation. Please see
http://www.denx.de/wiki/view/DULG/LinuxKernelArgs

> I also build kernel Linux 2.6.11.7 use tosati patch and config ,but when I want this kernel support virtual terminal it hang.May I correct it?

You probably missed to define correct boot arguments, especially a
correct console device; note that 2.6 uses ttyCPM0 instead of ttyS0,
etc.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
I don't know if it's what you want, but it's what you get.  :-)
                      - Larry Wall in <10502@jpl-devvax.JPL.NASA.GOV>