Re: What is the correct way to indicate an unassigned PCI resource ?

[Gabriel Paubert <paubert@iram.es>]

On Tue, Dec 05, 2006 at 03:41:19PM +1100, Benjamin Herrenschmidt wrote:
> On Mon, 2006-12-04 at 14:22 +0000, Alan wrote:
> 
> > The discussion I was having was about sl82cxx and handling unassigned
> > resources. The zero address isn't relevant to that.
> 
> Well, actually, it's unclear to me wether the resource is unassigned or
> has been assigned to 0 :-) And in the later case, why claim'ing it
> fails.

Well, I don't have the PCI specification, but I have a device with the 
following gem in its errata (name edited and changed to <Device>):

""The <Device> contains two PCI base registers to allow for both greater 
flexibility in tightly constrained I/O space as well as the "on the fly" 
option to access the <Device> registers from either I/O or memory space. 
Both PCI base registers contained in the <Device> will accept the value 
of "zero" as a valid and decodable address. This differs from the PCI 2.1 
specification, where a zero value being written to the PCI base register 
should disable the register space. <Device> will continue to decode for 
register accesses using the value "zero" written to the PCI_BS register 
as the base address for decoding.""

which makes me suspect that a base address of zero really should mean
unassigned and is a way to disable base registers on a region by region
basis.

Now the fun with this device is that the I/O region occupies 4kB, so 
it leads to serious conflicts since there is also an ISA bridge in
the system (no 8259 anymore, serial console dead, etc...). The best
way to make this bug harmless is to write all ones to said base
register (it has 32 bit). This moves it to an address which cannot 
be generated by the host bridge (unless you program it in a really 
weird way).

Whatever a specification says, you'll always find some device that
has a bug in this area.

	Regards,
	Gabriel