From: linas@austin.ibm.com (Linas Vepstas)
To: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: arnd@arndb.de, linuxppc-dev@ozlabs.org
Subject: [PATCH 5/12] spidernet: spidernet: add support for Celleb
Date: Thu, 15 Feb 2007 18:48:16 -0600 [thread overview]
Message-ID: <20070216004816.GE8192@austin.ibm.com> (raw)
In-Reply-To: <20070216004325.GA8192@austin.ibm.com>
This patch adds or changes some HW specific settings for spider_net on
Celleb.
Signed-off-by: Kou Ishizaki <kou.ishizaki@toshiba.co.jp>
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
----
drivers/net/Kconfig | 2 +-
drivers/net/spider_net.c | 8 +++++++-
drivers/net/spider_net.h | 6 ++++--
3 files changed, 12 insertions(+), 4 deletions(-)
Index: linux-2.6.20-git4/drivers/net/Kconfig
===================================================================
--- linux-2.6.20-git4.orig/drivers/net/Kconfig 2007-02-15 17:50:33.000000000 -0600
+++ linux-2.6.20-git4/drivers/net/Kconfig 2007-02-15 17:54:57.000000000 -0600
@@ -2243,7 +2243,7 @@ config BNX2
config SPIDER_NET
tristate "Spider Gigabit Ethernet driver"
- depends on PCI && PPC_IBM_CELL_BLADE
+ depends on PCI && (PPC_IBM_CELL_BLADE || PPC_CELLEB)
select FW_LOADER
help
This driver supports the Gigabit Ethernet chips present on the
Index: linux-2.6.20-git4/drivers/net/spider_net.h
===================================================================
--- linux-2.6.20-git4.orig/drivers/net/spider_net.h 2007-02-15 17:53:49.000000000 -0600
+++ linux-2.6.20-git4/drivers/net/spider_net.h 2007-02-15 17:54:57.000000000 -0600
@@ -1,7 +1,8 @@
/*
- * Network device driver for Cell Processor-Based Blade
+ * Network device driver for Cell Processor-Based Blade and Celleb platform
*
* (C) Copyright IBM Corp. 2005
+ * (C) Copyright 2006 TOSHIBA CORPORATION
*
* Authors : Utz Bacher <utz.bacher@de.ibm.com>
* Jens Osterkamp <Jens.Osterkamp@de.ibm.com>
@@ -184,7 +185,8 @@ extern char spider_net_driver_name[];
/* pause frames: automatic, no upper retransmission count */
/* outside loopback mode: ETOMOD signal dont matter, not connected */
-#define SPIDER_NET_OPMODE_VALUE 0x00000063
+/* ETOMOD signal is brought to PHY reset. bit 2 must be 1 in Celleb */
+#define SPIDER_NET_OPMODE_VALUE 0x00000067
/*#define SPIDER_NET_OPMODE_VALUE 0x001b0062*/
#define SPIDER_NET_LENLMT_VALUE 0x00000908
Index: linux-2.6.20-git4/drivers/net/spider_net.c
===================================================================
--- linux-2.6.20-git4.orig/drivers/net/spider_net.c 2007-02-15 17:54:23.000000000 -0600
+++ linux-2.6.20-git4/drivers/net/spider_net.c 2007-02-15 17:54:57.000000000 -0600
@@ -1,7 +1,8 @@
/*
- * Network device driver for Cell Processor-Based Blade
+ * Network device driver for Cell Processor-Based Blade and Celleb platform
*
* (C) Copyright IBM Corp. 2005
+ * (C) Copyright 2006 TOSHIBA CORPORATION
*
* Authors : Utz Bacher <utz.bacher@de.ibm.com>
* Jens Osterkamp <Jens.Osterkamp@de.ibm.com>
@@ -1605,6 +1606,11 @@ spider_net_init_card(struct spider_net_c
spider_net_write_reg(card, SPIDER_NET_CKRCTRL,
SPIDER_NET_CKRCTRL_RUN_VALUE);
+
+ /* trigger ETOMOD signal */
+ spider_net_write_reg(card, SPIDER_NET_GMACOPEMD,
+ spider_net_read_reg(card, SPIDER_NET_GMACOPEMD) | 0x4);
+
}
/**
next prev parent reply other threads:[~2007-02-16 0:48 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <200701260724.l0Q7OISY027645@toshiba.co.jp>
2007-01-26 7:46 ` [PATCHSET] libata: PATA driver for Celleb Jeff Garzik
2007-02-14 5:19 ` Akira Iguchi
[not found] ` <200702140518.l1E5IoWX010896@toshiba.co.jp>
2007-02-14 5:29 ` Benjamin Herrenschmidt
2007-02-15 5:07 ` Jeff Garzik
2007-02-15 7:52 ` Benjamin Herrenschmidt
2007-02-15 10:41 ` Jens Osterkamp
2007-02-15 16:03 ` Jim Lewis
2007-02-15 17:14 ` Linas Vepstas
2007-02-15 18:09 ` Arnd Bergmann
2007-02-15 19:11 ` Linas Vepstas
2007-02-19 21:56 ` Alan
2007-02-19 21:21 ` Benjamin Herrenschmidt
2007-02-19 23:46 ` Alan
2007-02-19 23:17 ` Bartlomiej Zolnierkiewicz
2007-02-19 23:28 ` Benjamin Herrenschmidt
2007-02-19 23:18 ` Benjamin Herrenschmidt
2007-02-19 21:43 ` Benjamin Herrenschmidt
2007-02-20 8:14 ` Geert Uytterhoeven
2007-02-15 20:46 ` Benjamin Herrenschmidt
2007-02-16 0:18 ` [PATCHSET] spidernet, sungem_phy: consolidated patch series Linas Vepstas
2007-02-16 0:43 ` [PATCH 1/12]: sungem_phy: support bcm5461 phy, autoneg Linas Vepstas
2007-02-16 0:44 ` [PATCH 2/12]: spidernet: compile break Linas Vepstas
2007-02-16 0:45 ` [PATCH 3/12] spidernet: autoneg support for Celleb Linas Vepstas
2007-02-16 0:46 ` [PATCH 4/12] spidernet: load firmware when open Linas Vepstas
2007-02-16 0:48 ` Linas Vepstas [this message]
2007-02-16 0:49 ` [PATCH 6/12] spidernet: remove txram full logging Linas Vepstas
2007-02-16 0:50 ` [PATCH 7/12] spidernet: move medium variable into card struct Linas Vepstas
2007-02-16 0:52 ` [PATCH 8/12] Spidernet: separate hardware state from driver state Linas Vepstas
2007-02-16 0:53 ` [PATCH: 9/12]: spidernet: fix racy double-free of skb Linas Vepstas
2007-02-16 0:55 ` [PATCH 10/12] spidernet: transmit race Linas Vepstas
2007-02-16 0:57 ` [PATCH 11/12] spidernet: janitorial, typos Linas Vepstas
2007-02-16 0:58 ` [PATCH 12/12]: spidernet: maintainership Linas Vepstas
2007-02-16 14:46 ` [PATCH 1/12]: sungem_phy: support bcm5461 phy, autoneg Arnd Bergmann
2007-02-16 16:19 ` Linas Vepstas
2007-02-15 5:12 ` spidernet (was Re: [PATCHSET] libata: PATA driver for Celleb) Jeff Garzik
2007-02-15 7:52 ` Benjamin Herrenschmidt
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20070216004816.GE8192@austin.ibm.com \
--to=linas@austin.ibm.com \
--cc=arnd@arndb.de \
--cc=benh@kernel.crashing.org \
--cc=linuxppc-dev@ozlabs.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).