[PATCH 7/7] [POWERPC][SPI] spi_mpc83xx: allow use on any processors with QUICC Engine

[Anton Vorontsov <avorontsov@ru.mvista.com>]

Currently, all QE SPI controllers are almost the same comparing to
MPC83xx's, thus let's use that driver for them.

Tested to work on MPC85xx in loopback mode.

Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
---

This is respin. Hope this time it will get ack from the
PowerPC team.

 drivers/spi/Kconfig |   13 +++++++------
 1 files changed, 7 insertions(+), 6 deletions(-)

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b915711..a77ede5 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -124,16 +124,17 @@ config SPI_MPC52xx_PSC
 	  Controller in master SPI mode.
 
 config SPI_MPC83xx
-	tristate "Freescale MPC83xx SPI controller"
-	depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
+	tristate "Freescale MPC83xx/QUICC Engine SPI controller"
+	depends on SPI_MASTER && (PPC_83xx || QUICC_ENGINE) && EXPERIMENTAL
 	select SPI_BITBANG
 	help
-	  This enables using the Freescale MPC83xx SPI controller in master
-	  mode.
+	  This enables using the Freescale MPC83xx and QUICC Engine SPI
+	  controllers in master mode.
 
 	  Note, this driver uniquely supports the SPI controller on the MPC83xx
-	  family of PowerPC processors.  The MPC83xx uses a simple set of shift
-	  registers for data (opposed to the CPM based descriptor model).
+	  family of PowerPC processors, plus processors with QUICC Engine
+	  technology. This driver uses a simple set of shift registers for data
+	  (opposed to the CPM based descriptor model).
 
 config SPI_OMAP_UWIRE
 	tristate "OMAP1 MicroWire"
-- 
1.5.0.6