[PATCH 14/18] ide: remove obsoleted "idex=base[, ctl[, irq]]" kernel parameters

[Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>]

* Remove obsoleted "idex=base[,ctl[,irq]]" kernel parameters
  and update Documentation/ide.txt.

* Remove no longer needed ide_forced chipset type.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
-244 bytes (x86-32)

 Documentation/ide.txt     |   31 -------------------------------
 drivers/ide/ide-generic.c |    3 +--
 drivers/ide/ide-probe.c   |    3 +--
 drivers/ide/ide-proc.c    |    3 ---
 drivers/ide/ide.c         |   22 +++++-----------------
 drivers/ide/pci/cmd640.c  |    2 +-
 drivers/ide/setup-pci.c   |   11 -----------
 include/linux/ide.h       |    2 +-
 8 files changed, 9 insertions(+), 68 deletions(-)

Index: b/Documentation/ide.txt
===================================================================
--- a/Documentation/ide.txt
+++ b/Documentation/ide.txt
@@ -71,29 +71,6 @@ This driver automatically probes for mos
 ones), for the drives/geometries attached to those interfaces, and for the IRQ
 lines being used by the interfaces (normally 14, 15 for ide0/ide1).
 
-For special cases, interfaces may be specified using kernel "command line"
-options.  For example,
-
-	ide3=0x168,0x36e,10	/* ioports 0x168-0x16f,0x36e, irq 10 */
-
-Normally the irq number need not be specified, as ide.c will probe for it:
-
-	ide3=0x168,0x36e	/* ioports 0x168-0x16f,0x36e */
-
-The standard port, and irq values are these:
-
-	ide0=0x1f0,0x3f6,14
-	ide1=0x170,0x376,15
-	ide2=0x1e8,0x3ee,11
-	ide3=0x168,0x36e,10
-
-Note that the first parameter reserves 8 contiguous ioports, whereas the
-second value denotes a single ioport. If in doubt, do a 'cat /proc/ioports'.
-
-In all probability the device uses these ports and IRQs if it is attached
-to the appropriate ide channel.  Pass the parameter for the correct ide
-channel to the kernel, as explained above.
-
 Any number of interfaces may share a single IRQ if necessary, at a slight
 performance penalty, whether on separate cards or a single VLB card.
 The IDE driver automatically detects and handles this.  However, this may
@@ -259,14 +236,6 @@ Summary of ide driver parameters for ker
 			  Bigger values are safer than smaller ones.
 
  "idex=noprobe"		: do not attempt to access/use this interface
- 
- "idex=base"		: probe for an interface at the addr specified,
-			  where "base" is usually 0x1f0 or 0x170
-			  and "ctl" is assumed to be "base"+0x206
-			  
- "idex=base,ctl"	: specify both base and ctl
-
- "idex=base,ctl,irq"	: specify base, ctl, and irq number
 
  "idex=serialize"	: do not overlap operations on idex. Please note
 			  that you will have to specify this option for
Index: b/drivers/ide/ide-generic.c
===================================================================
--- a/drivers/ide/ide-generic.c
+++ b/drivers/ide/ide-generic.c
@@ -96,8 +96,7 @@ static int __init ide_generic_init(void)
 		ide_hwif_t *hwif = &ide_hwifs[i];
 
 		if (hwif->io_ports[IDE_DATA_OFFSET] &&
-		    (hwif->chipset == ide_unknown ||
-		     hwif->chipset == ide_forced))
+		    hwif->chipset == ide_unknown)
 			idx[i] = i;
 		else
 			idx[i] = 0xff;
Index: b/drivers/ide/ide-probe.c
===================================================================
--- a/drivers/ide/ide-probe.c
+++ b/drivers/ide/ide-probe.c
@@ -1514,8 +1514,7 @@ int ide_device_add_all(u8 *idx, const st
 		hwif = &ide_hwifs[idx[i]];
 
 		if (hwif->present) {
-			if (hwif->chipset == ide_unknown ||
-			    hwif->chipset == ide_forced)
+			if (hwif->chipset == ide_unknown)
 				hwif->chipset = ide_generic;
 			hwif_register_devices(hwif);
 		}
Index: b/drivers/ide/ide-proc.c
===================================================================
--- a/drivers/ide/ide-proc.c
+++ b/drivers/ide/ide-proc.c
@@ -46,9 +46,6 @@ static int proc_ide_read_imodel
 	int		len;
 	const char	*name;
 
-	/*
-	 * Neither ide_unknown nor ide_forced should be set at this point.
-	 */
 	switch (hwif->chipset) {
 		case ide_generic:	name = "generic";	break;
 		case ide_pci:		name = "pci";		break;
Index: b/drivers/ide/ide.c
===================================================================
--- a/drivers/ide/ide.c
+++ b/drivers/ide/ide.c
@@ -1349,8 +1349,6 @@ static int __init ide_setup(char *s)
 			"minus10", "four", "qd65xx", "ht6560b", "cmd640_vlb",
 			"dtc2278", "umc8672", "ali14xx", NULL };
 
-		hw_regs_t hwregs;
-
 		hw = s[3] - '0';
 		hwif = &ide_hwifs[hw];
 		i = match_parm(&s[4], ide_words, vals, 3);
@@ -1451,21 +1449,11 @@ static int __init ide_setup(char *s)
 			case -1: /* "noprobe" */
 				hwif->noprobe = 1;
 				goto done;
-
-			case 1:	/* base */
-				vals[1] = vals[0] + 0x206; /* default ctl */
-			case 2: /* base,ctl */
-				vals[2] = 0;	/* default irq = probe for it */
-			case 3: /* base,ctl,irq */
-				memset(&hwregs, 0, sizeof(hwregs));
-				ide_init_hwif_ports(&hwregs, vals[0], vals[1], &hwif->irq);
-				memcpy(hwif->io_ports, hwregs.io_ports, sizeof(hwif->io_ports));
-				hwif->irq      = vals[2];
-				hwif->noprobe  = 0;
-				hwif->chipset  = ide_forced;
-				goto obsolete_option;
-
-			case 0: goto bad_option;
+			case 0:
+			case 1:
+			case 2:
+			case 3:
+				goto bad_option;
 			default:
 				printk(" -- SUPPORT NOT CONFIGURED IN THIS KERNEL\n");
 				return 1;
Index: b/drivers/ide/pci/cmd640.c
===================================================================
--- a/drivers/ide/pci/cmd640.c
+++ b/drivers/ide/pci/cmd640.c
@@ -415,7 +415,7 @@ static void __init setup_device_ptrs (vo
 	cmd_hwif1 = &ide_hwifs[1]; /* default, if not found below */
 	for (i = 0; i < MAX_HWIFS; i++) {
 		ide_hwif_t *hwif = &ide_hwifs[i];
-		if (hwif->chipset == ide_unknown || hwif->chipset == ide_forced) {
+		if (hwif->chipset == ide_unknown) {
 			if (hwif->io_ports[IDE_DATA_OFFSET] == 0x1f0)
 				cmd_hwif0 = hwif;
 			else if (hwif->io_ports[IDE_DATA_OFFSET] == 0x170)
Index: b/drivers/ide/setup-pci.c
===================================================================
--- a/drivers/ide/setup-pci.c
+++ b/drivers/ide/setup-pci.c
@@ -41,17 +41,6 @@ static ide_hwif_t *ide_match_hwif(unsign
 	ide_hwif_t *hwif;
 
 	/*
-	 * Look for a hwif with matching io_base specified using
-	 * parameters to ide_setup().
-	 */
-	for (h = 0; h < MAX_HWIFS; ++h) {
-		hwif = &ide_hwifs[h];
-		if (hwif->io_ports[IDE_DATA_OFFSET] == io_base) {
-			if (hwif->chipset == ide_forced)
-				return hwif; /* a perfect match */
-		}
-	}
-	/*
 	 * Look for a hwif with matching io_base default value.
 	 * If chipset is "ide_unknown", then claim that hwif slot.
 	 * Otherwise, some other chipset has already claimed it..  :(
Index: b/include/linux/ide.h
===================================================================
--- a/include/linux/ide.h
+++ b/include/linux/ide.h
@@ -169,7 +169,7 @@ enum {		ide_unknown,	ide_generic,	ide_pc
 		ide_rz1000,	ide_trm290,
 		ide_cmd646,	ide_cy82c693,	ide_4drives,
 		ide_pmac,	ide_etrax100,	ide_acorn,
-		ide_au1xxx,	ide_palm3710,	ide_forced
+		ide_au1xxx,	ide_palm3710
 };
 
 typedef u8 hwif_chipset_t;