Re: [PATCH 3/6] powernv:idle: Restore LPCR on wakeup from deep-stop

[Gautham R Shenoy <ego@linux.vnet.ibm.com>]

On Tue, May 30, 2017 at 04:17:31PM +1000, Nicholas Piggin wrote:
> On Tue, 16 May 2017 14:19:45 +0530
> "Gautham R. Shenoy" <ego@linux.vnet.ibm.com> wrote:
> 
> > From: "Gautham R. Shenoy" <ego@linux.vnet.ibm.com>
> > 
> > On wakeup from a deep stop state which is supposed to lose the
> > hypervisor state, we don't restore the LPCR to the old value but set
> > it to a "sane" value via cur_cpu_spec->cpu_restore().
> > 
> > The problem is that the "sane" value doesn't include UPRT and the HR
> > bits which are required to run correctly in Radix mode.
> > 
> > Fix this on POWER9 onwards by restoring the LPCR value whatever it was
> > before executing the stop instruction.
> > 
> > Signed-off-by: Gautham R. Shenoy <ego@linux.vnet.ibm.com>
> 
> Yes I think we need this. I have a plan to rework some of
> that cpu_restore and early CPU init stuff, but for now we
> need this.
> 
> Does the OCC restore LPCR properly then we just trash it
> with ->cpu_restore(), or is it always junk?

The microcode restores LPCR to the value that the kernel asks it to
set to in pnv_save_sprs_for_deep_states() via the opal_slw_set_reg. So
it would be some sane state.

However when we return from stop to either the cpuidle or cpuhotplug,
we want LPCR to be restored to the value it hand when it entered stop.


> 
> Reviewed-by: Nicholas Piggin <npiggin@gmail.com>
> 
>

Thanks for the review.

--
Thanks and Regards
gautham.