[PATCH 1/2] powerpc: Document xmon options

[Gustavo Romero <gromero@linux.ibm.com>]

Document all options currently supported by xmon debugger.

Signed-off-by: Gustavo Romero <gromero@linux.ibm.com>
---
 .../admin-guide/kernel-parameters.txt         | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt
index 7ccd158b3894..6d495aab4d0b 100644
--- a/Documentation/admin-guide/kernel-parameters.txt
+++ b/Documentation/admin-guide/kernel-parameters.txt
@@ -5305,3 +5305,22 @@
 			A hex value specifying bitmask with supplemental xhci
 			host controller quirks. Meaning of each bit can be
 			consulted in header drivers/usb/host/xhci.h.
+
+	xmon		[PPC]
+			Format: { early | on | rw | ro | off }
+			Controls if xmon debugger is enabled. Default is off.
+			Passing only "xmon" is equivalent to "xmon=early".
+			early	Call xmon as early as possible on boot; xmon
+				debugger is called from setup_arch().
+			on	xmon debugger hooks will be installed so xmon
+				is only called on a kernel crash. Default mode,
+				i.e. either "ro" or "rw" mode, is controlled
+				with CONFIG_XMON_DEFAULT_RO_MODE.
+			rw	xmon debugger hooks will be installed so xmon
+				is called only on a kernel crash, mode is write,
+				meaning SPR registers, memory and, other data
+				can be written using xmon commands.
+			ro 	same as "rw" option above but SPR registers,
+				memory, and other data can't be written using
+				xmon commands.
+			off	xmon is disabled.
-- 
2.17.1