Re: [PATCH] ASoC: fsl_sai: Clean code for synchronize mode

[Nicolin Chen <nicoleotsuka@gmail.com>]

On Mon, Aug 03, 2020 at 11:17:54AM +0800, Shengjiu Wang wrote:
> TX synchronous with RX: The RMR is no need to be changed when
> Tx is enabled, the other configuration in hw_params() is enough for

Probably you should explain why RMR can be removed, like what
it really does so as to make it clear that there's no such a
relationship between RMR and clock generating.

Anyway, this is against the warning comments in the driver:
	/*
	 * For SAI master mode, when Tx(Rx) sync with Rx(Tx) clock, Rx(Tx) will
	 * generate bclk and frame clock for Tx(Rx), we should set RCR4(TCR4),
	 * RCR5(TCR5) and RMR(TMR) for playback(capture), or there will be sync
	 * error.
	 */

So would need to update it.

> clock generation. The TCSR.TE is no need to enabled when only RX
> is enabled.

You are correct if there's only RX running without TX joining.
However, that's something we can't guarantee. Then we'd enable
TE after RE is enabled, which is against what RM recommends:

# From 54.3.3.1 Synchronous mode in IMX6SXRM
# If the receiver bit clock and frame sync are to be used by
# both the transmitter and receiver, it is recommended that
# the receiver is the last enabled and the first disabled.

I remember I did this "ugly" design by strictly following what
RM says. If hardware team has updated the RM or removed this
limitation, please quote in the commit logs.

> +		if (!sai->synchronous[TX] && sai->synchronous[RX] && !tx) {
> +			regmap_update_bits(sai->regmap, FSL_SAI_xCSR((!tx), ofs),
> +					   FSL_SAI_CSR_TERE, FSL_SAI_CSR_TERE);
> +		} else if (!sai->synchronous[RX] && sai->synchronous[TX] && tx) {
> +			regmap_update_bits(sai->regmap, FSL_SAI_xCSR((!tx), ofs),
> +					   FSL_SAI_CSR_TERE, FSL_SAI_CSR_TERE);

Two identical regmap_update_bits calls -- both on !tx (RX?)