Re: [PATCH v2 23/36] dt-bindings: soc: fsl: cpm_qe: Add QUICC Engine (QE) QMC controller

[Rob Herring <robh@kernel.org>]

On Thu, Aug 08, 2024 at 09:11:16AM +0200, Herve Codina wrote:
> Add support for the QMC (QUICC Multichannel Controller) available in
> some PowerQUICC SoC that uses a QUICC Engine (QE) block such as MPC8321.
> 
> This QE QMC is similar to the CPM QMC except that it uses UCCs (Unified
> Communication Controllers) instead of SCCs (Serial Communication
> Controllers). Also, compared against the CPM QMC, this QE QMC does not
> use a fixed area for the UCC/SCC parameters area but it uses a dynamic
> area allocated and provided to the hardware at runtime.
> Last point, the QE QMC can use a firmware to have the QMC working in
> 'soft-qmc' mode.
> 
> Signed-off-by: Herve Codina <herve.codina@bootlin.com>
> ---
>  .../soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml        | 197 ++++++++++++++++++
>  1 file changed, 197 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml
> 
> diff --git a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml
> new file mode 100644
> index 000000000000..71ae64cb8a4f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml
> @@ -0,0 +1,197 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/soc/fsl/cpm_qe/fsl,qe-ucc-qmc.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: PowerQUICC QE QUICC Multichannel Controller (QMC)
> +
> +maintainers:
> +  - Herve Codina <herve.codina@bootlin.com>
> +
> +description:
> +  The QMC (QUICC Multichannel Controller) emulates up to 64 channels within one
> +  serial controller using the same TDM physical interface routed from TSA.
> +
> +properties:
> +  compatible:
> +    items:
> +      - enum:
> +          - fsl,mpc8321-ucc-qmc
> +      - const: fsl,qe-ucc-qmc
> +
> +  reg:
> +    items:
> +      - description: UCC (Unified communication controller) register base
> +      - description: Dual port ram base
> +
> +  reg-names:
> +    items:
> +      - const: ucc_regs

_regs is redundant.

> +      - const: dpram
> +
> +  interrupts:
> +    maxItems: 1
> +    description: UCC interrupt line in the QE interrupt controller
> +
> +  fsl,tsa-serial:
> +    $ref: /schemas/types.yaml#/definitions/phandle-array
> +    items:
> +      - items:
> +          - description: phandle to TSA node
> +          - enum: [1, 2, 3, 4, 5]
> +            description: |
> +              TSA serial interface (dt-bindings/soc/qe-fsl,tsa.h defines these
> +              values)
> +               - 1: UCC1
> +               - 2: UCC2
> +               - 3: UCC3
> +               - 4: UCC4
> +               - 5: UCC5
> +    description:
> +      Should be a phandle/number pair. The phandle to TSA node and the TSA
> +      serial interface to use.
> +
> +  fsl,soft-qmc:
> +    $ref: /schemas/types.yaml#/definitions/string
> +    description:
> +      Soft QMC firmware name to load. If this property is omitted, no firmware
> +      are used.

"firmware-name" doesn't work here?

> +
> +  '#address-cells':
> +    const: 1
> +
> +  '#size-cells':
> +    const: 0
> +
> +patternProperties:
> +  '^channel@([0-9]|[1-5][0-9]|6[0-3])$':

Unit-addresses are typically hex.

> +    description:
> +      A channel managed by this controller
> +    type: object
> +    additionalProperties: false
> +
> +    properties:
> +      compatible:
> +        items:
> +          - enum:
> +              - fsl,mpc8321-ucc-qmc-hdlc
> +          - const: fsl,qe-ucc-qmc-hdlc
> +          - const: fsl,qmc-hdlc
> +
> +      reg:
> +        minimum: 0
> +        maximum: 63
> +        description:
> +          The channel number
> +
> +      fsl,operational-mode:
> +        $ref: /schemas/types.yaml#/definitions/string
> +        enum: [transparent, hdlc]
> +        default: transparent
> +        description: |
> +          The channel operational mode
> +            - hdlc: The channel handles HDLC frames
> +            - transparent: The channel handles raw data without any processing
> +
> +      fsl,reverse-data:
> +        $ref: /schemas/types.yaml#/definitions/flag
> +        description:
> +          The bit order as seen on the channels is reversed,
> +          transmitting/receiving the MSB of each octet first.
> +          This flag is used only in 'transparent' mode.
> +
> +      fsl,tx-ts-mask:
> +        $ref: /schemas/types.yaml#/definitions/uint64
> +        description:
> +          Channel assigned Tx time-slots within the Tx time-slots routed by the
> +          TSA to this cell.
> +
> +      fsl,rx-ts-mask:
> +        $ref: /schemas/types.yaml#/definitions/uint64
> +        description:
> +          Channel assigned Rx time-slots within the Rx time-slots routed by the
> +          TSA to this cell.
> +
> +      fsl,framer:
> +        $ref: /schemas/types.yaml#/definitions/phandle
> +        description:
> +          phandle to the framer node. The framer is in charge of an E1/T1 line
> +          interface connected to the TDM bus. It can be used to get the E1/T1 line
> +          status such as link up/down.
> +
> +    allOf:
> +      - if:
> +          properties:
> +            compatible:
> +              not:
> +                contains:
> +                  const: fsl,qmc-hdlc

"fsl,qmc-hdlc" is always present in compatible. This is only true if 
compatible is not present. If that's what you wanted, just do:

if:
  not:
    required: [compatible]


> +        then:
> +          properties:
> +            fsl,framer: false

Err, actually, you can do 1 better with just:

dependencies:
  fsl,framer: [compatible]


> +
> +    required:
> +      - reg
> +      - fsl,tx-ts-mask
> +      - fsl,rx-ts-mask
> +
> +required:
> +  - compatible
> +  - reg
> +  - reg-names
> +  - interrupts
> +  - fsl,tsa-serial
> +  - '#address-cells'
> +  - '#size-cells'
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/soc/qe-fsl,tsa.h>
> +
> +    qmc@a60 {
> +        compatible = "fsl,mpc8321-ucc-qmc", "fsl,qe-ucc-qmc";
> +        reg = <0x3200 0x200>,
> +              <0x10000 0x1000>;
> +        reg-names = "ucc_regs", "dpram";
> +        interrupts = <35>;
> +        interrupt-parent = <&qeic>;
> +        fsl,soft-qmc = "fsl_qe_ucode_qmc_8321_11.bin";
> +
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        fsl,tsa-serial = <&tsa FSL_QE_TSA_UCC4>;
> +
> +        channel@16 {
> +            /* Ch16 : First 4 even TS from all routed from TSA */
> +            reg = <16>;
> +            fsl,operational-mode = "transparent";
> +            fsl,reverse-data;
> +            fsl,tx-ts-mask = <0x00000000 0x000000aa>;
> +            fsl,rx-ts-mask = <0x00000000 0x000000aa>;
> +        };
> +
> +        channel@17 {
> +            /* Ch17 : First 4 odd TS from all routed from TSA */
> +            reg = <17>;
> +            fsl,operational-mode = "transparent";
> +            fsl,reverse-data;
> +            fsl,tx-ts-mask = <0x00000000 0x00000055>;
> +            fsl,rx-ts-mask = <0x00000000 0x00000055>;
> +        };
> +
> +        channel@19 {
> +            /* Ch19 : 8 TS (TS 8..15) from all routed from TSA */
> +            compatible = "fsl,mpc8321-ucc-qmc-hdlc",
> +                         "fsl,qe-ucc-qmc-hdlc",
> +                         "fsl,qmc-hdlc";
> +            reg = <19>;
> +            fsl,operational-mode = "hdlc";
> +            fsl,tx-ts-mask = <0x00000000 0x0000ff00>;
> +            fsl,rx-ts-mask = <0x00000000 0x0000ff00>;
> +            fsl,framer = <&framer>;
> +        };
> +    };
> -- 
> 2.45.0
>