Hello everyone,

I have the Freescale's MPC8313erdb eval board and run the latest stable linux
kernel version (linux-2.6.30.5).

After creating a VLAN device (e.g. eth0.2) a VLAN tag is also inserted into
frames that don't relate to a VLAN device. This is the case for frames that
are directly sent through a standard ethernet interface (e.g. eth0).

When creating a VLAN device the gianfar driver enables the  hardware supported
VLAN tagging on TX frames. This is done by setting the VLINS bit of the TCTRL
register inside the function gianfar_vlan_rx_register().
The problem is that every outgoing frame will be tagged.  For frames from an
interface like eth0 the VLN bit of the FCB isn't set. Therefore the eTSEC uses
the content of the Default VLAN control word register (DFVLAN) to tag the
frame. As long as this register will not be modified after a reset of the
controller the outgoing frames will be tagged with VID = 0 (priority tagged
frames).

The following patch solves this problem.

diff -uprN linux-2.6.30.5_orig//drivers/net/gianfar.c linux-2.6.30.5/drivers/net/gianfar.c
--- linux-2.6.30.5_orig//drivers/net/gianfar.c  2009-08-16 23:19:38.000000000 +0200
+++ linux-2.6.30.5/drivers/net/gianfar.c        2009-08-22 10:38:28.000000000 +0200
@@ -1309,6 +1309,7 @@ static int gfar_start_xmit(struct sk_buf
       u32 bufaddr;
       unsigned long flags;
       unsigned int nr_frags, length;
+       u32 tempval;

       base = priv->tx_bd_base;

@@ -1385,13 +1386,30 @@ static int gfar_start_xmit(struct sk_buf
               gfar_tx_checksum(skb, fcb);
       }

-       if (priv->vlgrp && vlan_tx_tag_present(skb)) {
-               if (unlikely(NULL == fcb)) {
-                       fcb = gfar_add_fcb(skb);
-                       lstatus |= BD_LFLAG(TXBD_TOE);
-               }
+       if (priv->vlgrp) {
+               if (vlan_tx_tag_present(skb)) {
+                       if (unlikely(NULL == fcb)) {
+                               fcb = gfar_add_fcb(skb);
+                               lstatus |= BD_LFLAG(TXBD_TOE);
+                       }
+
+                       /* Enable VLAN tag insertion for frames from VLAN devices */
+                       tempval = gfar_read(&priv->regs->tctrl);
+                       if ( !(tempval & TCTRL_VLINS) ) {
+                               tempval |= TCTRL_VLINS;
+                               gfar_write(&priv->regs->tctrl, tempval);
+                       }

-               gfar_tx_vlan(skb, fcb);
+                       gfar_tx_vlan(skb, fcb);
+               }
+               else {
+                       /* Disable VLAN tag insertion for frames that are not from a VLAN device */
+                       tempval = gfar_read(&priv->regs->tctrl);
+                       if ( tempval & TCTRL_VLINS ) {
+                               tempval &= ~TCTRL_VLINS;
+                               gfar_write(&priv->regs->tctrl, tempval);
+                       }
+               }
       }