From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <36ACDDB2.6DA8ACA7@mitre.org> Date: Mon, 25 Jan 1999 16:10:12 -0500 From: Frank McPherson MIME-Version: 1.0 To: linuxppc-dev@lists.linuxppc.org Subject: xmon, BAT structure, etc. Content-Type: text/plain; charset=us-ascii Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: xmon doesn't seem to exist in the linuxppc sources any more and I'm having trouble getting the one from the linuxppc.org 2.1.24 sources to compile with 2.2.0-pre5, which is the latest version I was able to pull from vger's anonymous cvs before it started always refusing connections. Where can I get it, or something equivalent? What's the best way to debug the platform-specific code that's run shortly after the bootloader? I'm working on getting linux up and running on a non-prep, non-pci VME board with a 603e and having some trouble with it. I've got the kernel uncompressing down to where it should be, but it traps when it gets a bit of the way in to init/main.c. When I write the contents of the BAT structure to dual port RAM on the VME bus, I get all zeros, leading me to believe I'm not setting thins up correctly down in the platform-specific sections. Thanks, Frank -- Frank H. McPherson IV The MITRE Corporation [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]] [[ the message 'unsubscribe' to linuxppc-dev-request@lists.linuxppc.org ]]