From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <371E0313.C0FF665C@fi.infn.it> Date: Wed, 21 Apr 1999 18:55:47 +0200 From: Simone Piccardi MIME-Version: 1.0 To: linuxppc-dev Subject: Un-Setting VME3PCI Master Master Enable on MVME2431 Content-Type: text/plain; charset=us-ascii Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: Hi, today I got another "little" trouble with our board. We finally get a dataway display that cannot work. After many attempts to use it (it was perfectly working in other crates) we try to go back to the default configuration of the board (I switched to VME3PCI Master Master Enable = N according to what said in the mailing list to boot the kernel) and everything went working. The manual said: N do not enable the VME Bus Interface So is this only related to the PPCBug (and with a working kernel all will be OK?) Or I have to worry? Probably this is a stupid question, but as I said I'm totally new to VME. Thanks -- Simone Piccardi Microsoft is NOT the answer. Microsoft is the Question. The answer is: "NO!" [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]