From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <379E8995.31CA136B@cadvision.com> Date: Tue, 27 Jul 1999 22:39:49 -0600 From: Neil Jolly MIME-Version: 1.0 To: ian geiser CC: "linuxppc-dev@lists.linuxppc.org" , LinuxPPC List Subject: Re: G3 Upgrade Questions.... References: <379E3513.738D0449@msoe.edu> Content-Type: text/plain; charset=us-ascii Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: ian geiser wrote: > Hello, > I just installed a G3 upgrade card into my powercenter132 > It is a 400Mhz with 1Meg at 200Mhz.... > It registers under MacOS perfectly but i get the following under > proc/cpuinfo: > processor : 0 > cpu : 750 > temperature : 0 C <--Is this correct?! > clock : 195MHz <-- Is this correct?! > revision : 130.1 > bogomips : 399.77 > zero pages : total 0 (0Kb) current: 0 (0Kb) hits: 0/1084 (0%) > machine : Power Macintosh > motherboard : AAPL,7300 MacRISC > memory : 112MB > > it only registers 195 Mhz and 0C for the temp... is the correct? > i am running Kernel 2.2.10 Here's a peek at my cpu info. A 233 G3 clocked to 292 with 83mhz bus, and runs around 106 degrees F. Obviously the temp is not accurate, but clock seems to be pretty close. processor : 0 cpu : 750 temperature : 0 C clock : 290MHz revision : 2.2 bogomips : 581.63 zero pages : total 0 (0Kb) current: 0 (0Kb) hits: 0/558 (0%) machine : Power Macintosh motherboard : AAPL,Gossamer MacRISC L2 cache : 512K unified pipelined-syncro-burst memory : 96MB Neil [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]