From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <3810FB75.87486F32@netx4.com> Date: Fri, 22 Oct 1999 20:04:05 -0400 From: Dan Malek MIME-Version: 1.0 To: "linuxppc-embedded@lists.linuxppc.org" Subject: Linux on CLLF: Don't ask, I'll tell Content-Type: text/plain; charset=us-ascii Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: I decided to post this before I forget. This information is only important if you want to use the 10/100 Ethernet on the Embedded Planet RPX-CLLF (or Classic). Well, here is something that is important in any case. The CLLF is "just" a Classic without the PCI and a smaller form factor. To build a kernel for the CLLF, just select RPXC (or RPX-Classic) and don't select the PCI configuration. There is no menu selection for the CLLF. I don't have the Ethernet PHY completed for this board. So, we need help from the boot ROM monitor to initialize it. At the main menu, select 'O' for On-board I/O tests. At the next menu, select '9' for the 100 Mbit Ethernet. At the next menu, select '0' (that's zero) to toggle between 10 and 100 so it matches your network. Now, at this point I also downloaded the kernel, so I don't know if you need to actually perform some I/O at this point. Make sure you hit enough ESCs to get back to the main menu.... When the kernel boots, ignore the FEC messages about link status. It is looking at registers and bits that are not appropriate for the PHY on this board. -- Dan ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/