From mboxrd@z Thu Jan 1 00:00:00 1970 MIME-Version: 1.0 Message-Id: <38DAAFB4.19073@mta5> Date: Fri, 24 Mar 2000 07:58:44 +0800 (CST) From: "zzh" To: Steven Tarr Cc: linuxppc-embedded@lists.linuxppc.org Subject: Re:Re: About rs232 on motorola mpc8260 ads board Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: >David-- > >I've been using the MPC8260ADS board(ENGversion) for about 3months. >I have Port1(SCC1) connectedtoa SUN tty port and have had no problems. >There is demo oe on the Motorola site that show you how to program theport.As to the ranges of outpuut voltages,I have not measured them. > >Try >http://www.mot-sps.com/products/microprocessors/32_bit/mpc8000/mpc8260_devtools.html >cheers-- >SteveTarr > > I am using the pilot version of the ads board,and indeed run the init8260 example from mot web site.How do you connect the pins? According to ads manual,pin 2 from connector is tx,pin 3 is rx, ,and i also connect pin 4( DTR connect with SCC1 CD on PC14) with pin 6(DSR).The output volatege is 0-5V.but the logic is 232. I think it should be i had not connectted the pins correctly? At the time of writing,when i reading the ads manual,i found CTS(pin 8) connect to SCC1's RTS on PD29.But the Init program did not program this pin?How about eng version's connection?Should i program this pin? >zzhwrote: > >>**Sentviathelinuxppc-embeddedmaillist.Seehttp://lists.linuxppc.org/ >-- >SteveTarr >tarr@lucent.com >303-538-4056 > > _____________________________________________ 首都在线--中国人的网上家园 http://www.263.net @263.net中国最大的在线邮局 http://freemail.263.net ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/