Hi,<br><br>I&#39;m trying to boot Linux on&nbsp; AVNET 440gx eval board but no luck so far.<br>What I did are that I downloaded a plain 2.6.20 kernel from <a href="http://kernel.org">kernel.org</a>,<br>configured with 440GX, OCOTEA target (I&#39;m not sure OCOTEA is correct target),
<br>then loaded the kernel image via tftp&nbsp; and tried to boot with bootelf command.<br>But I had no output message from Linux.<br><br>I suspected setting of Linux serial console. So I changed the kernel parameter to <br>&quot;ttyS0,19200&quot; which I suppose correct becuase this is the minicom setting.
<br>But still didn&#39;t work.<br><br>The board comes with u-boot 1.0.2 with some fixes.&nbsp; I&#39;m checking the u-boot <br>source code (might be some hint in there) and the serial device <br>initialization code in Linux.<br>
<br>Has anyone had experiece with Linux on AVNET 440GX board? <br>Any advise would be appreciated !<br><br>-<br>Ken<br><br>------<br><br>=&gt; tftp<br>Waiting for PHY auto negotiation to complete.. done<br>ENET Speed is 100 Mbps - FULL duplex connection
<br>*** Warning: no boot file name; using &#39;6501A8C0.img&#39;<br>Using ppc_440x_eth2 device<br>TFTP from server <a href="http://192.168.1.1">192.168.1.1</a>; our IP address is <a href="http://192.168.1.101">192.168.1.101
</a><br>Filename &#39;6501A8C0.img&#39;.<br>Load address: 0x100000<br>Loading: #################################################################<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; #################################################################
<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; #################################<br>done<br>Bytes transferred = 832121 (cb279 hex)<br>=&gt; bootelf<br>Loading .text @ 0x01000000 (15316 bytes)<br>Loading .data @ 0x01004000 (700416 bytes)<br>Clearing .bss @ 0x010af000 (8500 bytes)
<br>## Starting application at 0x01000000 ...<br><br>(no output after this message)<br>