From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <39EF2BC1.E464D72F@rational.com> Date: Thu, 19 Oct 2000 13:13:37 -0400 From: Scott Hankin MIME-Version: 1.0 To: linuxppc-dev@lists.linuxppc.org Subject: 2.4.0-test10 boot failure on Powerbook G3 Content-Type: text/plain; charset=us-ascii Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: Howdy - I've been successfully running 2.4 from Paulus' Linux Kernel Page until 2.4.0-test10 came out. Now I can't boot at all. I get the initial brief message page and see the messages: . . . setup_arch: bootmem arch: exit then the screen goes black, and I see vector: 300 at pc = c016d060, lr = c016c8f4, msr = 9032, sp = c07b1cc0 [c07b1c10] dar = 7ac, dsisr = 40000000 current = c07b0000, pid = 1, comm = swapper mon> and everything is dead. My only option is to cycle power. I'm running a PowerBook G3 Series (Wallstreet) with 160MB RAM and a 2 GB partition on a 6 GB disk. As always, I initially build with the .config file that comes over from Paulus' site before making local option changes. What changed in 2.4.0-test10 (vs. test9) that would explain this? Since I am so early in the boot process (no keyboard control even) I'm at a loss as to how to proceed. Is anyone else successfully running Paulus' 2.4.0-test10 from a PowerBook? - Scott ----------------------------- Scott Hankin (shankin@rational.com) In the beginning, there was nothing, then Rational Software God said, "Let there be light." And there 20 Maguire Road was light. There was still nothing, but Lexington, MA 02421 you could see it a lot better. ** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/