From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <3ADDAF55.308E1014@iiic.ethz.ch> Date: Wed, 18 Apr 2001 17:14:29 +0200 From: Michel =?iso-8859-1?Q?D=E4nzer?= MIME-Version: 1.0 To: Alain RICHARD Cc: Benjamin Herrenschmidt , linuxppc-dev@lists.linuxppc.org Subject: Re: benh 2.4.4-pre3, Titanium and AirPort References: <20010418115224.25139@mailhost.mipsys.com> Content-Type: text/plain; charset=iso-8859-1 Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: Alain RICHARD wrote: > I have built PCMCIA in the kernel, but the problem is that to load > orinico_cs, we must first load the PCMCIA support because it depends > on ds that depends on a working pcmcia adaptor driver (i82365 in > previous powerbooks). > > The problem seems that i82365 seems not recognizing the cardbus on > titanium. lspci output is : > > 01:1a.0 CardBus bridge: Texas Instruments PCI1211 > Flags: bus master, medium devsel, latency 16, IRQ 58 > Memory at 80080000 (32-bit, non-prefetchable) [size=4K] > Bus: primary=01, secondary=02, subordinate=05, sec-latency=32 > I/O window 1: 00000000-00000003 > 16-bit legacy interface ports at 1011 I have the same on my Pismo and I use the yenta_socket module. I'm writing this from an Airport connection. :) -- Earthling Michel Dänzer (MrCooper) \ Debian GNU/Linux (powerpc) developer CS student, Free Software enthusiast \ XFree86 and DRI project member ** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/