* Re: RE: Uncompress Ok, but cannot run linux kernel...
@ 2001-05-08 11:21 zjuzhou
0 siblings, 0 replies; only message in thread
From: zjuzhou @ 2001-05-08 11:21 UTC (permalink / raw)
To: linuxppc-embedded
> Tom:
> I stumbled into the same problem a while ago.
>
> While I did not use a hardware debugger I used the sample demonstrating
> serial output to find that the Montavista kernel stops at the rfi
> instruction which is used to simultanoeusly turn on instruction and data
> address translation and to set the instruction pointer to the (remapped)
> start_here label. Unfortunately I lost my PPC hardware (405GP Walnut
> board) before I could find any solution.
>
I meet same problem now.When I add CONFIG_MODULES into config file
HHL 2.2.14 works well(my borad is mpc850),but after add it ,I meet same
situation :after uncompressing kernel ,it do noting.It shoud display
LINUX_BANNER.
If you find the solution,tell me.Thanks.
Dross
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2001-05-08 11:21 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2001-05-08 11:21 RE: Uncompress Ok, but cannot run linux kernel zjuzhou
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).