From mboxrd@z Thu Jan 1 00:00:00 1970 From: zjuzhou@163.net MIME-Version: 1.0 Message-Id: <3AF7D69E.03527@bjapp1> Date: Tue, 8 May 2001 19:21:02 +0800 (CST) To: linuxppc-embedded@lists.linuxppc.org Subject: Re: RE: Uncompress Ok, but cannot run linux kernel... Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: > Tom: > I stumbled into the same problem a while ago. > > While I did not use a hardware debugger I used the sample demonstrating > serial output to find that the Montavista kernel stops at the rfi > instruction which is used to simultanoeusly turn on instruction and data > address translation and to set the instruction pointer to the (remapped) > start_here label. Unfortunately I lost my PPC hardware (405GP Walnut > board) before I could find any solution. > I meet same problem now.When I add CONFIG_MODULES into config file HHL 2.2.14 works well(my borad is mpc850),but after add it ,I meet same situation :after uncompressing kernel ,it do noting.It shoud display LINUX_BANNER. If you find the solution,tell me.Thanks. Dross ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/