rtlinux interrupt response

rtlinux interrupt response

[srinivas pulipati]

hi all,

i have downloaded denx rtlinux and ported it to my custom board for
study purpose.
my board is based on MPC860. rtlinux is working fine.

i tried to measure the interrupt response time.
i am getting best case is 30microseconds and worst case is
150microsenconds.
couldn't understand why this much difference.
can anybody explain? or is there any thing wrong in my port?

thanks
srinivas


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Re: rtlinux interrupt response

[Wolfgang Grandegger]

On 04/17/2002 09:34 AM, srinivas pulipati wrote:

>hi all,
>
>i have downloaded denx rtlinux and ported it to my custom board for
>study purpose.
>my board is based on MPC860. rtlinux is working fine.
>

This is off topic here. Very likely you get better help from the
rtlinux.org or rtai.org mailing lists.

>
>
>i tried to measure the interrupt response time.
>i am getting best case is 30microseconds and worst case is
>150microsenconds.
>couldn't understand why this much difference.
>can anybody explain? or is there any thing wrong in my port?
>

With RTAI I measured sometime ago on a TQM860L, 50MHz,
8KB data cache:

                             Min     Max     Average:

  No load                :   13us    46us    14us

  while : ; do a=a ; done:   13us    46us    18us

  ping -f to target      :   13us    46us    19us


If I remember correctly, rtlinux has bigger overhead (more code).

BTW: Denx has dropped support for rtlinux quite a while ago
because of fsmlabs license policy (AFAIK, there is no open rtlinux
for the MPC 8xx).

Hope it helps,

Wolfgang.


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/