From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <3CFE54F6.1060605@embeddededge.com> Date: Wed, 05 Jun 2002 14:14:14 -0400 From: Dan Malek MIME-Version: 1.0 To: frowand@mvista.com Cc: Dave Strout , linuxppc-embedded@lists.linuxppc.org Subject: Re: Basics -- what tools for Walnut? References: <3CFE4C3A.4070604@linuxfoundary.com> <3CFE4F42.DDB1D5CE@mvista.com> Content-Type: text/plain; charset=us-ascii; format=flowed Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: Frank Rowand wrote: > I suspect that is a fairly old tool chain that you are using. In the past, the practice was to inform people when changes were made that required a minimum revision of tools to operate properly. Simply telling people "your toolchain is too old" isn't helpful..... What version of tools is required to build this properly? Why doesn't the check in comment indicate this information when the change was made? > Try modifying arch/ppc/Makefile to use > > -mcpu=403 Or, just remove it since it doesn't perform any useful function. On the newer tools, it's required to allow the assembler to not bitch about 4xx unique instructions, another non-useful function, IMHO. Thanks. -- Dan ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/