Total memory = 256MB; using 512kB for hash table (at c0380000) Linux version 2.6.8 (root@sengor) (gcc version 3.3.5 (Debian 1:3.3.5-2)) #8 Tue Nov 9 15:59:40 CET 2004 PReP architecture On node 0 totalpages: 65536 DMA zone: 65536 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/sda2 console=ttyS0 PID hash table entries: 2048 (order 11: 16384 bytes) time_init: decrementer frequency = 16.657680 MHz Console: colour dummy device 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 255232k available (2204k kernel code, 1144k data, 160k init, 0k highmem) Calibrating delay loop... 299.00 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 4096 bytes) NET: Registered protocol family 16 PCI: Probing PCI hardware Setting PCI interrupts for a "Utah (Powerstack II Pro4000)" PCI: Cannot allocate resource region 5 of device 0000:00:01.1 Linux Plug and Play Support v0.97 (c) Adam Belay SCSI subsystem initialized PCI: Enabling device 0000:00:08.0 (0080 -> 0082) matroxfb: Matrox Millennium (PCI) detected matroxfb: 640x480x8bpp (virtual: 640x6553) matroxfb: framebuffer at 0xC1800000, mapped to 0xf1800000, size 4194304 fb0: MATROX frame buffer device fb0: initializing hardware Installing knfsd (copyright (C) 1996 okir@monad.swb.de). isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Console: switching to colour frame buffer device 80x30 Macintosh non-volatile memory driver v1.1 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx W82C105: IDE controller at PCI slot 0000:00:01.1 PCI: Enabling device 0000:00:01.1 (0000 -> 0001) W82C105: chipset revision 5 W82C105: 100% native mode on irq 14 W82C105: dma_base is invalid (0x0000) ide0: W82C105 Bus-Master DMA disabled (BIOS) W82C105: dma_base is invalid (0x0000) ide1: W82C105 Bus-Master DMA disabled (BIOS) Probing IDE interface ide0... hda: ST380021A, ATA DISK drive hdb: IBM-DTLA-305040, ATA DISK drive hda: selected PIO 4 (120ns) (0240) hdb: selected PIO 4 (120ns) (0240) Using anticipatory io scheduler ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... Probing IDE interface ide1... Probing IDE interface ide2... ide2: Wait for ready failed before probe ! Probing IDE interface ide3... ide3: Wait for ready failed before probe ! hda: max request size: 128KiB hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=65535/16/63 hda: hda1 hdb: max request size: 128KiB hdb: 80418240 sectors (41174 MB) w/380KiB Cache, CHS=65535/16/63 hdb: hdb1 PCI: Enabling device 0000:00:02.0 (0000 -> 0003) sym0: <825a> rev 0x13 at pci 0000:00:02.0 irq 15 sym0: No NVRAM, ID 7, Fast-10, SE, parity checking sym0: SCSI BUS has been reset. scsi0 : sym-2.1.18j Vendor: IBM Model: DPSS-309170N Rev: S93E Type: Direct-Access ANSI SCSI revision: 03 sym0:0:0: tagged command queuing enabled, command queue depth 16. scsi(0:0:0:0): Beginning Domain Validation sym0:0: wide asynchronous. sym0:0: FAST-10 WIDE SCSI 20.0 MB/s ST (100.0 ns, offset 8) scsi(0:0:0:0): Ending Domain Validation st: Version 20040403, fixed bufsize 32768, s/g segs 256 SCSI device sda: 16777216 512-byte hdwr sectors (8590 MB) SCSI device sda: drive cache: write back sda: sda1 sda2 sda3 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 mice: PS/2 mouse device common for all mice serio: i8042 AUX port at 0x60,0x64 irq 12 atkbd.c: keyboard reset failed on isa0060/serio1 serio: i8042 KBD port at 0x60,0x64 irq 1 atkbd.c: keyboard reset failed on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 32768) NET: Registered protocol family 1 NET: Registered protocol family 17 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 160k init 36k pmac 4k chrp 4k openfirmware Adding 262136k swap on /dev/sda3. Priority:-1 extents:1 EXT3 FS on sda2, internal journal Linux Tulip driver version 1.1.13 (May 11, 2002) PCI: Enabling device 0000:00:04.0 (0000 -> 0003) tulip0: EEPROM default media type Autosense. tulip0: Index #0 - Media AUI (#2) described by a 21140 non-MII (0) block. tulip0: Index #1 - Media MII (#11) described by a 21140 MII PHY (1) block. tulip0: MII transceiver #8 config 3100 status 786b advertising 01e1. eth0: Digital DS21140 Tulip rev 34 at 0x1800, 08:00:3E:29:2E:45, IRQ 11. de2104x PCI Ethernet driver v0.7 (Mar 17, 2004) kjournald starting. Commit interval 5 seconds EXT3 FS on hda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on hdb1, internal journal EXT3-fs: mounted filesystem with ordered data mode. eth0: Setting full-duplex based on MII#8 link partner capability of 45e1. CSLIP: code copyright 1989 Regents of the University of California PPP generic driver version 2.4.2 ip_tables: (C) 2000-2002 Netfilter core team ip_conntrack version 2.1 (2048 buckets, 16384 max) - 296 bytes per conntrack eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin and others PCI: Enabling device 0000:00:06.0 (0000 -> 0003) eth1: 0000:00:06.0, 00:02:B3:1A:8C:72, IRQ 10. Board assembly 751767-003, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. Secondary interface chip i82555. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x8e695832). PPP BSD Compression module registered PPP Deflate Compression module registered eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. UDP: bad checksum. From 213.97.110.54:5889 to 83.129.181.72:4472 ulen 27 UDP: bad checksum. From 82.90.52.67:12826 to 83.129.248.97:4223 ulen 27 eth1: TX underrun, threshold adjusted. eth1: TX underrun, threshold adjusted. sym0:0:0: ABORT operation started. sym0:0:0: ABORT operation timed-out. sym0:0:0: ABORT operation started. sym0:0:0: ABORT operation timed-out. sym0:0:0: ABORT operation started. sym0:0:0: ABORT operation timed-out. sym0:0:0: ABORT operation started. sym0:0:0: ABORT operation timed-out. sym0:0:0: DEVICE RESET operation started. sym0:0:0: DEVICE RESET operation timed-out. sym0:0:0: BUS RESET operation started. sym0: SCSI BUS reset detected. sym0: SCSI BUS has been reset. sym0:0:0: BUS RESET operation complete. eth1: TX underrun, threshold adjusted. UDP: short packet: From 217.126.164.250:5676 33/27 to 83.129.160.15:11124 eth1: TX underrun, threshold adjusted. UDP: short packet: From 82.254.199.92:1024 132/26 to 83.129.199.46:571 UDP: bad checksum. From 217.126.164.250:5676 to 83.129.174.118:5667 ulen 27 UDP: bad checksum. From 82.50.40.247:7689 to 83.129.1.186:4120 ulen 28 UDP: bad checksum. From 218.90.225.199:3357 to 83.129.16.247:3258 ulen 26 UDP: short packet: From 217.126.164.250:2960 11925/27 to 83.129.63.189:4662 UDP: short packet: From 83.129.64.153:888 0/27 to 83.129.70.178:13054 UDP: bad checksum. From 217.126.164.250:5676 to 83.129.70.178:3454 ulen 33 UDP: bad checksum. From 217.126.164.250:5676 to 83.129.70.178:12855 ulen 80