memec virtex 2 Pro

memec virtex 2 Pro

[mcnernbm]

[-- Attachment #1: Type: text/plain, Size: 406 bytes --]

Has anyone had any success getting linux to boot on a memc viretx 2 board? 
 I am trying to replicate the steps to get the kernel built for the ml300 
but run error after error in doing so.  The make zImage is borken and 
fails all the time. Anybody that has success with the memec virtex 2 pro 
or the xilinx ml300 board it would be greatly appreciated if you could 
explain how you did so. 
Thanks
Brett 

[-- Attachment #2: Type: text/html, Size: 544 bytes --]

Re: memec virtex 2 Pro

[S. van Beek]

[-- Attachment #1: Type: text/plain, Size: 1107 bytes --]

Hi there

We have montavista linux running on a memec virtex II-pro ff672 board with communications 2 module here. 
What error do you get? What steps do you need help with? I can send you a working .config file if you want.

Regards
Sander van Beek
  ----- Original Message ----- 
  From: mcnernbm@notes.udayton.edu 
  To: linuxppc-embedded@ozlabs.org 
  Sent: Friday 27 May 2005 4:45
  Subject: memec virtex 2 Pro



  Has anyone had any success getting linux to boot on a memc viretx 2 board?  I am trying to replicate the steps to get the kernel built for the ml300 but run error after error in doing so.  The make zImage is borken and fails all the time. Anybody that has success with the memec virtex 2 pro or the xilinx ml300 board it would be greatly appreciated if you could explain how you did so.   
  Thanks 
  Brett 


------------------------------------------------------------------------------


  _______________________________________________
  Linuxppc-embedded mailing list
  Linuxppc-embedded@ozlabs.org
  https://ozlabs.org/mailman/listinfo/linuxppc-embedded

[-- Attachment #2: Type: text/html, Size: 2389 bytes --]

Re: memec virtex 2 Pro

[Andrei Konovalov]

mcnernbm@notes.udayton.edu wrote:
> Has anyone had any success getting linux to boot on a memc viretx 2 board? 
>  I am trying to replicate the steps to get the kernel built for the ml300 
> but run error after error in doing so.  The make zImage is borken and 
> fails all the time. Anybody that has success with the memec virtex 2 pro 
> or the xilinx ml300 board it would be greatly appreciated if you could 
> explain how you did so. 
> Thanks
> Brett 
> 

What kernel tree are you using?

Thanks,
Andrei

> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> Linuxppc-embedded mailing list
> Linuxppc-embedded@ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-embedded