Andrey Volkov wrote:

urwithsudheer wrote:

Hello All,
I am working with a pci based vga card. I have connected the vga card next to the pci slot of my target processor on the baseboard.
I have connected a monitor to the vga card.
When i boot linux from minicom, i could see all the kernel log messages on both the minicom and vga card monitor. But on the vga monitor, i could not see any messages after asking for login as below:
.
.

Mounting filesystems
Running depmod
Setting up networking on loopback device:
Setting up networking on eth0:
eth0: PHY is Marvell 88E11x1 (1410cc2)
Adding static route for default gateway to 192.168.3.1:
Setting nameserver to 192.168.0.1 in /etc/resolv.conf:
Starting inetd:

login:

Though i am entering my login and passwd at the minicom, nothing comes on to the vga monitor. But i am able to write to vga monitor using the following commands from minicom:

# echo "Hello" > /dev/tty1
# echo "Hi " > /dev/tty1
My requirement is to get on the vga monitor whatever i am typing on the minicom after logging into the linux like .
ls or pwd commands.

Anyone pl help me.

Thanks & Regards
Sudheer

See Documentation/kernel-parameters.txt.

If be short, add:

console=/dev/ttySxx console=/dev/tty1

(both) to a kernel parameters string.

I got upto login prompt on the vga monitor only after giving the above parameters in my u-boot bootargs.
u-boot=> set bootargs console=tty1 console=ttyS0,115200.

I have added in the serial driver linux/drivers/serial/serial_core.c
   in the function uart_write(struct tty_struct *tty, const unsigned char * buf, int count)
   The lines in the if directive.

if (c <= 0)
                        break;
                memcpy(circ->buf + circ->head, buf, c);
/* added to test vga */
#if 1
                memcpy(tempbuf, circ->buf + circ->head, c);
                  for(i=0;i<c;i++)
                  printk("%c", tempbuf[i]);
#endif

circ->head = (circ->head + c) & (UART_XMIT_SIZE - 1);
                buf += c;

Then as i expected, all the letters i enter in the minicom came twice on the minicom.

login:rroooott
Password: Password:
login  on `ttyS0'ogin  on `ttyS0'login[83]: root

 ~ # ~ # llss
 ~ # ~ # iiffccoonnffiigg

And whatever i enter on the minicom also gets print on the vga monitor but only once.
When i comment the if directive, On the vga monitor i could see only upto login prompt.

I don't know why the printk statement i added in the serial driver prints on the vga monitor.

As said by shkatikannan, i am going through the vga driver to copy to the frambuffer. But yet couldn't get it exactly in the code where to copy.

Please tell me if i am in the wrong path.

Thanks & Regards
Sudheer

--
Regards
Andrey