Re: [PATCH] cpm2_pic: Allow correct flow_types for port C interrupts

[Mark Ware <mware@elphinstone.net>]

Any comments/Acks/Nacks on this patch?

- Mark

Mark Ware wrote:
> CPM2 Port C interrupts can be either falling edge, or either edge.
> Other external interrupts are either falling edge or active low.
> 
> Signed-Off-By: Mark Ware <mware@elphinstone.net>
> ---
>  arch/powerpc/sysdev/cpm2_pic.c |   29 ++++++++++++++++++++++-------
>  1 files changed, 22 insertions(+), 7 deletions(-)
> 
> diff --git a/arch/powerpc/sysdev/cpm2_pic.c b/arch/powerpc/sysdev/cpm2_pic.c
> index 78f1f7c..179822c 100644
> --- a/arch/powerpc/sysdev/cpm2_pic.c
> +++ b/arch/powerpc/sysdev/cpm2_pic.c
> @@ -141,13 +141,28 @@ static int cpm2_set_irq_type(unsigned int virq, unsigned int flow_type)
>  	struct irq_desc *desc = get_irq_desc(virq);
>  	unsigned int vold, vnew, edibit;
>  
> -	if (flow_type == IRQ_TYPE_NONE)
> -		flow_type = IRQ_TYPE_LEVEL_LOW;
> -
> -	if (flow_type & IRQ_TYPE_EDGE_RISING) {
> -		printk(KERN_ERR "CPM2 PIC: sense type 0x%x not supported\n",
> -			flow_type);
> -		return -EINVAL;
> +	/* Port C interrupts are either IRQ_TYPE_EDGE_FALLING or
> +	 * IRQ_TYPE_EDGE_BOTH (default).  All others are IRQ_TYPE_EDGE_FALLING
> +	 * or IRQ_TYPE_LEVEL_LOW (default)
> +	 */
> +	if (src >= CPM2_IRQ_PORTC15 && src <= CPM2_IRQ_PORTC0) {
> +		if (flow_type == IRQ_TYPE_NONE)
> +			flow_type = IRQ_TYPE_EDGE_BOTH;
> +
> +		if (flow_type & ~IRQ_TYPE_EDGE_BOTH) {
> +			printk(KERN_ERR "CPM2 PIC: sense type 0x%x not supported\n",
> +				flow_type);
> +			return -EINVAL;
> +		}
> +	} else {
> +		if (flow_type == IRQ_TYPE_NONE)
> +			flow_type = IRQ_TYPE_LEVEL_LOW;
> +
> +		if (flow_type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_LEVEL_HIGH)) {
> +			printk(KERN_ERR "CPM2 PIC: sense type 0x%x not supported\n",
> +				flow_type);
> +			return -EINVAL;
> +		}
>  	}
>  
>  	desc->status &= ~(IRQ_TYPE_SENSE_MASK | IRQ_LEVEL);