[PATCH 1/3] [PATCH 1/3]powerpc/eeh: Propagate needs_freset flag to device at PE

[PATCH 1/3] [PATCH 1/3]powerpc/eeh: Propagate needs_freset flag to device at PE

[Richard A Lary]

From: Richard A Lary <rlary@linux.vnet.ibm.com>

  For multifunction adapters with a PCI bridge or switch as the device
  at the Partitionable Endpoint(PE), if one or more devices below PE
  sets dev->needs_freset, that value will be set for the PE device.

  In other words, if any device below PE requires a fundamental reset
  the PE will request a fundamental reset.

Signed-off-by: Richard A Lary <rlary@linux.vnet.ibm.com>
---
  arch/powerpc/platforms/pseries/eeh.c |   48 	42 +	6 -	0 !
  1 file changed, 42 insertions(+), 6 deletions(-)

Index: b/arch/powerpc/platforms/pseries/eeh.c
===================================================================
--- a/arch/powerpc/platforms/pseries/eeh.c
+++ b/arch/powerpc/platforms/pseries/eeh.c
@@ -448,6 +448,39 @@ void eeh_clear_slot (struct device_node
  	raw_spin_unlock_irqrestore(&confirm_error_lock, flags);
  }

+void __eeh_set_pe_freset(struct device_node *parent, unsigned int *freset)
+{
+	struct device_node *dn;
+
+	for_each_child_of_node(parent, dn) {
+		if (PCI_DN(dn)) {
+
+			struct pci_dev *dev = PCI_DN(dn)->pcidev;
+
+			if (dev && dev->driver)
+				*freset |= dev->needs_freset;
+
+			__eeh_set_pe_freset(dn, freset);
+		}
+	}
+}
+
+void eeh_set_pe_freset(struct device_node *dn, unsigned int *freset)
+{
+	struct pci_dev *dev;
+	dn = find_device_pe(dn);
+
+	/* Back up one, since config addrs might be shared */
+	if (!pcibios_find_pci_bus(dn) && PCI_DN(dn->parent))
+		dn = dn->parent;
+
+	dev = PCI_DN(dn)->pcidev;
+	if (dev)
+		*freset |= dev->needs_freset;
+
+	__eeh_set_pe_freset(dn, freset);
+}
+
  /**
   * eeh_dn_check_failure - check if all 1's data is due to EEH slot freeze
   * @dn device node
@@ -736,18 +769,21 @@ int pcibios_set_pcie_reset_state(struct
  /**
   * rtas_set_slot_reset -- assert the pci #RST line for 1/4 second
   * @pdn: pci device node to be reset.
- *
- *  Return 0 if success, else a non-zero value.
   */

  static void __rtas_set_slot_reset(struct pci_dn *pdn)
  {
-	struct pci_dev *dev = pdn->pcidev;
+	unsigned int freset = 0;

-	/* Determine type of EEH reset required by device,
-	 * default hot reset or fundamental reset
+	/* Determine type of EEH reset required for
+	 * Partitionable Endpoint, a hot-reset (1)
+	 * or a fundamental reset (3).
+	 * A fundamental reset required by any device under
+	 * Partitionable Endpoint trumps hot-reset.
  	 */
-	if (dev && dev->needs_freset)
+	eeh_set_pe_freset(pdn->node, &freset);
+
+	if (freset)
  		rtas_pci_slot_reset(pdn, 3);
  	else
  		rtas_pci_slot_reset(pdn, 1);

Re: [PATCH 1/3] [PATCH 1/3]powerpc/eeh: Propagate needs_freset flag to device at PE

[Benjamin Herrenschmidt]

On Fri, 2011-04-22 at 12:59 -0700, Richard A Lary wrote:
> From: Richard A Lary <rlary@linux.vnet.ibm.com>
> 
>   For multifunction adapters with a PCI bridge or switch as the device
>   at the Partitionable Endpoint(PE), if one or more devices below PE
>   sets dev->needs_freset, that value will be set for the PE device.
> 
>   In other words, if any device below PE requires a fundamental reset
>   the PE will request a fundamental reset.
> 
> Signed-off-by: Richard A Lary <rlary@linux.vnet.ibm.com>
> ---

This patch and the next one didn't apply cleanly for some reason.

I've hand applied both and will push to -next in a few minutes, please
let me know if it's all correct.

The third one, I gave up as I was running out of time, please re-post a
version that applies on top of powerpc-next.

Cheers,
Ben.

>   arch/powerpc/platforms/pseries/eeh.c |   48 	42 +	6 -	0 !
>   1 file changed, 42 insertions(+), 6 deletions(-)
> 
> Index: b/arch/powerpc/platforms/pseries/eeh.c
> ===================================================================
> --- a/arch/powerpc/platforms/pseries/eeh.c
> +++ b/arch/powerpc/platforms/pseries/eeh.c
> @@ -448,6 +448,39 @@ void eeh_clear_slot (struct device_node
>   	raw_spin_unlock_irqrestore(&confirm_error_lock, flags);
>   }
> 
> +void __eeh_set_pe_freset(struct device_node *parent, unsigned int *freset)
> +{
> +	struct device_node *dn;
> +
> +	for_each_child_of_node(parent, dn) {
> +		if (PCI_DN(dn)) {
> +
> +			struct pci_dev *dev = PCI_DN(dn)->pcidev;
> +
> +			if (dev && dev->driver)
> +				*freset |= dev->needs_freset;
> +
> +			__eeh_set_pe_freset(dn, freset);
> +		}
> +	}
> +}
> +
> +void eeh_set_pe_freset(struct device_node *dn, unsigned int *freset)
> +{
> +	struct pci_dev *dev;
> +	dn = find_device_pe(dn);
> +
> +	/* Back up one, since config addrs might be shared */
> +	if (!pcibios_find_pci_bus(dn) && PCI_DN(dn->parent))
> +		dn = dn->parent;
> +
> +	dev = PCI_DN(dn)->pcidev;
> +	if (dev)
> +		*freset |= dev->needs_freset;
> +
> +	__eeh_set_pe_freset(dn, freset);
> +}
> +
>   /**
>    * eeh_dn_check_failure - check if all 1's data is due to EEH slot freeze
>    * @dn device node
> @@ -736,18 +769,21 @@ int pcibios_set_pcie_reset_state(struct
>   /**
>    * rtas_set_slot_reset -- assert the pci #RST line for 1/4 second
>    * @pdn: pci device node to be reset.
> - *
> - *  Return 0 if success, else a non-zero value.
>    */
> 
>   static void __rtas_set_slot_reset(struct pci_dn *pdn)
>   {
> -	struct pci_dev *dev = pdn->pcidev;
> +	unsigned int freset = 0;
> 
> -	/* Determine type of EEH reset required by device,
> -	 * default hot reset or fundamental reset
> +	/* Determine type of EEH reset required for
> +	 * Partitionable Endpoint, a hot-reset (1)
> +	 * or a fundamental reset (3).
> +	 * A fundamental reset required by any device under
> +	 * Partitionable Endpoint trumps hot-reset.
>   	 */
> -	if (dev && dev->needs_freset)
> +	eeh_set_pe_freset(pdn->node, &freset);
> +
> +	if (freset)
>   		rtas_pci_slot_reset(pdn, 3);
>   	else
>   		rtas_pci_slot_reset(pdn, 1);