Re: [PATCH v5 2/5] powerpc/85xx: add HOTPLUG_CPU support

[Scott Wood <scottwood@freescale.com>]

On 05/11/2012 06:53 AM, Zhao Chenhui wrote:
\> +#if defined(CONFIG_FSL_BOOKE) || defined(CONFIG_6xx)
> +extern void __flush_disable_L1(void);
> +#endif

Prototypes aren't normally guarded by ifdefs.

> +static void __cpuinit smp_85xx_mach_cpu_die(void)
> +{
> +	unsigned int cpu = smp_processor_id();
> +	u32 tmp;
> +
> +	local_irq_disable();
> +	idle_task_exit();
> +	generic_set_cpu_dead(cpu);
> +	mb();
> +
> +	mtspr(SPRN_TCR, 0);
> +
> +	__flush_disable_L1();
> +	tmp = (mfspr(SPRN_HID0) & ~(HID0_DOZE|HID0_SLEEP)) | HID0_NAP;
> +	mtspr(SPRN_HID0, tmp);
> +
> +	/* Enter NAP mode. */
> +	tmp = mfmsr();
> +	tmp |= MSR_WE;
> +	mb();
> +	mtmsr(tmp);
> +	isync();

Need isync after writing to HID0.

> +		/*
> +		 * We don't set the BPTR register here upon it points
> +		 * to the boot page properly.
> +		 */
> +		mpic_reset_core(hw_cpu);

That comment's wording is hard to follow -- maybe s/upon it points/since
it already points/

> +		/* wait until core is ready... */
> +		if (!spin_event_timeout(in_be32(&spin_table->addr_l) == 1,
> +						10000, 100)) {
> +			pr_err("%s: timeout waiting for core %d to reset\n",
> +							__func__, hw_cpu);
> +			ret = -ENOENT;
> +			goto out;
> +		}

We need to fix U-Boot to write addr_l last (with an msync beforehand).

> -#ifdef CONFIG_KEXEC
> +#if defined(CONFIG_KEXEC) || defined(CONFIG_HOTPLUG_CPU)

Let's not grow lists like this.  Is there any harm in building it
unconditionally?

-Scott