Re: PSC in UART mode on TQM5200S

["Leopold Stotch" <l.butterz@gmail.com>]

Thanks, i'll try the both ways.
I'm still afraid of killing factory UBoot without
BDI2000 or working X30 jumper :-)

On 9/19/07, Grant Likely <grant.likely@secretlab.ca> wrote:
> On 9/19/07, Leopold Stotch <l.butterz@gmail.com> wrote:
> > Thank you for the answer, Grant !
> > I knew nothing about port_config register before your answer :-(
> > I haven't changed any processor registers yet
> > because i'm still searching where i can do this.
> > Can you tell me, is it UBoot specific or kernel specific or both ?
> > And i already know about MPC5200's device tree in 2.6.x kernel but not in
> > 2.4.x...
>
> It is best to do it in u-boot; but if you cannot (or don't want to)
> change your u-boot image, then you can fix up the port_config value
> during early kernel boot.
>
> Cheers,
> g.
>
> --
> Grant Likely, B.Sc., P.Eng.
> Secret Lab Technologies Ltd.
> grant.likely@secretlab.ca
> (403) 399-0195
>


-- 
Best regards,
Leopold Stotch