Hi Michael,
 
Thanks for commenting on my CPC925 EDAC driver. I am on vacation this week and will integrate your suggestions next week.
 
I am also thinking of adding EDAC NMI support for the AMD8131 chip, which is a HyperTransport Tunnel device that hosts two PCI-X bridges. If enabled, each PCI-X bridge could generate NMI interrupt request package upstream, with vector identifier = 0. 
 
The CPC925 user mannual, p111, says that "This interrupt vector is used to set a corresponding interrupt latch", does this mean MPIC interrupt pin#0 would be latched on receiving NMI request package?
 
However, the pin#0 has been specified for Internal I2C master interrupt, so it would have to share hwirq #0 with NMI interrupt?
 
Thanks a lot!
 
Best regards,
 
Harry


      ___________________________________________________________ 
  好玩贺卡等你发，邮箱贺卡全新上线！ 
http://card.mail.cn.yahoo.com/