Re: [PATCH] powerpc/cell: Remove the Cell QPACE code.

[Arnd Bergmann <arnd@arndb.de>]

On Thursday 26 November 2015 13:39:09 Thomas Huth wrote:
> On 26/11/15 13:09, Michael Ellerman wrote:
> > On Thu, 2015-11-26 at 11:47 +0100, Thomas Huth wrote:
> > 
> >> On 26/11/15 01:59, Rashmica Gupta wrote:
> > 
> >>> All users of QPACE have upgraded to QPACE2 so remove the Cell QPACE code.
> >>>
> >>> Signed-off-by: Rashmica Gupta <rashmicy@gmail.com>
> >>> ---
> >>>  arch/powerpc/boot/Makefile                |   2 -
> >>>  arch/powerpc/configs/ppc64_defconfig      |   1 -
> >>>  arch/powerpc/platforms/cell/Kconfig       |   5 -
> >>>  arch/powerpc/platforms/cell/Makefile      |   3 -
> >>>  arch/powerpc/platforms/cell/qpace_setup.c | 148 ------------------------------
> >>>  5 files changed, 159 deletions(-)
> >>>  delete mode 100644 arch/powerpc/platforms/cell/qpace_setup.c
> >>
> >> There one more reference to qpace in the file
> >>  Documentation/devicetree/bindings/serial/8250.txt
> >> ... you might want to remove that, too.
> > 
> > There's also one in drivers/tty/serial/of_serial.c.
> > 
> > Arnd said he already had a patch to remove those, not sure if he's sent it
> > though.
> 
> He apparently did:
> 
>  https://lkml.org/lkml/2015/11/16/454
> 
> So the change to the file in Documentation should ideally go also into
> his patch instead, I think.

I think Greg is currently backlogged on all patches sent to him, but they
should show up in linux-next once he's caught up after Thanksgiving.

	Arnd