The 2.6.25 kernel dosen't run on pq2fads based board

["Matvejchikov Ilya" <matvejchikov@gmail.com>]

Hi all!

There is a problem with 2.6.25.4 kernel on the pq2fads based board.
The board resets after "MMU:exit" called (early debuging is used).See
the attached log:

========
## Booting kernel from Legacy Image at 00200000 ...
   Image Name:   Linux-2.6.25.4
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    1534783 Bytes =  1.5 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
## Flattened Device Tree blob at 00800000
   Booting using the fdt blob at 0x800000
   Loading Device Tree to 007fe000, end 007fffff ... OK
Xid mach(): done
MMU:enter
MMU:hw init
MMU:mapin
MMU:setio
MMU:exit
<<---- the reset was here :(

U-Boot 1.3.3-dirty (Jun  2 2008 - 15:43:45)

MPC8260 Reset Status: Check Stop, External Soft, External Hard

MPC8260 Clock Configuration
 - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq  25-75 , Core Freq 100-300
 - dfbrg 1, corecnf 0x1a, busdf 4, cpmdf 1, plldf 1, pllmf 4, pcidf 3
 - vco_out  330000000, scc_clk   82500000, brg_clk   20625000
 - cpu_clk  264000000, cpm_clk  165000000, bus_clk   66000000

CPU:   MPC8260 (HiP4 Rev 14, Mask C.0 5K25A) at 264 MHz
========

Can anyone help me with this?

Thanks.