Re: SystemACE on Kernel 2.6

[Yoshio Kashiwagi <kashiwagi@co-nss.co.jp>]

Hi,

The mark of BRAM is good at bootloop.
Priority is given to specified initial pc if -start_address is specified
by an opt file. Before starting a Linux kernel, can TestApp_Memory or a
TestApp_Peripheral program be started from CF?

The opt file which I am using is as follows.

-jprog
-hw implementation/download.bit
-ace cfboot.ace
-board ml405
-target ppc_hw
-elf zImage.elf
-start_address 0x00400000

Best Regards,

Yoshio Kashiwagi - Nissin Systems

> Hi Grant likely,
> 
> I got kernel 2.6.20 from kernel.org and I want boot it on XUP Virtex 
II Pro
> University board.
> I edited the Makefile putting:
>  ARCH? = ppc
>  CROSS_COMPILE? = ppc_4xx-
> But I can't see anything about SystemACE driver on make menuconfig 
from
> this Kernel. How can I add SystemACE controler?
> 
> I compiled the kernel repeatedly generating a file zImage.elf. I used 
this
> file with the genace.tcl from Xilinx and this opt file:
> -jprog
> -board user
> -target ppc_hw
> -hw implementation/download.bit
> -elf zImage.elf
> -configdevice devicenr 1 idcode 0x1127e093 irlength 14 partname 
xc2vp30
> -debugdevice devicenr 1 cpunr 1
> -ace system.ace
> 
> to generated ace file and put it in FAT16 partition of CF card, like a 
lot
> of references in web. But it doesn't works!
> Which IP cores must be present in my project of the EDK?
> Still speaking in the EDK Did i have to mark bram with ppc_405_0_
bootloop? 
> Did I have to mark bram whit any software project?
> 
> My work in with Linux on Virtex don't work. I am almost dropping...
> 
> Thanks!!