* orinoco_cs on linuxppc_2_4/linux-2.4-benh
@ 2002-01-18 2:38 Josh Huber
2002-01-19 1:52 ` John & Trudy Phillips
0 siblings, 1 reply; 2+ messages in thread
From: Josh Huber @ 2002-01-18 2:38 UTC (permalink / raw)
To: linuxppc-dev
I've decided to update the kernel on my laptop (Lombard 400),
currently it's running 2.4.11-pre4-ben0, which seems to work fine,
except I can't get usbmidi working with it.
usbmidi works (afaict) with the current 2.4.18-pre4(-ben0)? trees from
either linuxppc_2_4 or Ben's tree. However, both of them seem to
break my wireless card. The link to the base (an airport) appears to
be good, however no packets are transmitted/received over the link:
with the newer kernels:
iwconfig:
eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
Bit Rate:1Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:15/92 Signal level:-74 dBm Noise level:-89 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dmesg:
hermes.c: 3 Oct 2001 David Gibson <hermes@gibson.dropbear.id.au>
orinoco.c 0.09a (David Gibson <hermes@gibson.dropbear.id.au> and others)
orinoco_cs.c 0.09 (David Gibson <hermes@gibson.dropbear.id.au> and others)
eth1: Station identity 001f:0001:0004:0034
eth1: Looks like a Lucent/Agere firmware version 4.52
eth1: Ad-hoc demo mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:60:1D:F1:04:67
eth1: Station name "HERMES I"
eth1: ready
eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
Anyone else have this working with current kernels?
with the older kernel:
iwconfig:
eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
dmesg:
hermes.c: 3 Oct 2001 David Gibson <hermes@gibson.dropbear.id.au>
orinoco.c 0.08 (David Gibson <hermes@gibson.dropbear.id.au> and others)
orinoco_cs.c 0.08 (David Gibson <hermes@gibson.dropbear.id.au> and others)
eth1: Station identity 001f:0001:0004:0034
eth1: Looks like a Lucent/Agere firmware version 4.52
eth1: Ad-hoc demo mode supported.
eth1: WEP supported, "128"-bit key.
eth1: MAC address 00:60:1D:F1:04:67
eth1: Station name "HERMES I"
eth1: Allowed channels mask: 0x000007ff
eth1: ready
eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
If you need any more info, just ask,
--
Josh Huber
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: orinoco_cs on linuxppc_2_4/linux-2.4-benh
2002-01-18 2:38 orinoco_cs on linuxppc_2_4/linux-2.4-benh Josh Huber
@ 2002-01-19 1:52 ` John & Trudy Phillips
0 siblings, 0 replies; 2+ messages in thread
From: John & Trudy Phillips @ 2002-01-19 1:52 UTC (permalink / raw)
To: Josh Huber; +Cc: linuxppc-dev
I have the Orinoco Silver card working with a 550MHz Titanium Powerbook.
I am using the following:
kernel : linuxppc 2.4.17-rc1
modules: radeon 90560 0
orinoco_cs 5424 1
orinoco 36016 0 [orinoco_cs]
hermes 6288 0 [orinoco_cs orinoco]
ds 8720 1 [orinoco_cs]
yenta_socket 11088 1
pcmcia_core 43104 0 [orinoco_cs ds yenta_socket]
pcmcia/config: ...
card "Lucent Technologies WaveLAN/IEEE Adapter"
version "Lucent Technologies", "WaveLAN/IEEE"
bind "orinoco_cs"
...
device "orinoco_cs"
class "network" module "hermes", "orinoco", "orinoco_cs"
pcmcia/config.opts:
# Ti Powerbook resources
include port 0x0fff-0x1fff
include memory 0x80000000-0x80ffffff
include port 0x100-0xaff
# Everything else commented out
pcmcia/wireless.opts
*,*,*,*)
INFO="Wavelan IEEE example (Lucent default settings)"
ESSID="xxxxxxxx"
MODE="Managed"
KEY="xxxxxxx"
Let me know if this is close enough to your setup to help.
On Thu, 17 Jan 2002, Josh Huber wrote:
>
> I've decided to update the kernel on my laptop (Lombard 400),
> currently it's running 2.4.11-pre4-ben0, which seems to work fine,
> except I can't get usbmidi working with it.
>
> usbmidi works (afaict) with the current 2.4.18-pre4(-ben0)? trees from
> either linuxppc_2_4 or Ben's tree. However, both of them seem to
> break my wireless card. The link to the base (an airport) appears to
> be good, however no packets are transmitted/received over the link:
>
> with the newer kernels:
>
> iwconfig:
> eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
> Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
> Bit Rate:1Mb/s Tx-Power=15 dBm Sensitivity:1/3
> Retry limit:4 RTS thr:off Fragment thr:off
> Power Management:off
> Link Quality:15/92 Signal level:-74 dBm Noise level:-89 dBm
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>
> dmesg:
> hermes.c: 3 Oct 2001 David Gibson <hermes@gibson.dropbear.id.au>
> orinoco.c 0.09a (David Gibson <hermes@gibson.dropbear.id.au> and others)
> orinoco_cs.c 0.09 (David Gibson <hermes@gibson.dropbear.id.au> and others)
> eth1: Station identity 001f:0001:0004:0034
> eth1: Looks like a Lucent/Agere firmware version 4.52
> eth1: Ad-hoc demo mode supported
> eth1: WEP supported, 104-bit key
> eth1: MAC address 00:60:1D:F1:04:67
> eth1: Station name "HERMES I"
> eth1: ready
> eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
>
>
> Anyone else have this working with current kernels?
>
> with the older kernel:
>
> iwconfig:
> eth1 IEEE 802.11-DS ESSID:"huber_net" Nickname:"mystic"
> Mode:Managed Frequency:2.412GHz Access Point: 00:60:1D:1D:3E:0E
> Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
> Retry limit:4 RTS thr:off Fragment thr:off
> Encryption key:off
> Power Management:off
>
> dmesg:
> hermes.c: 3 Oct 2001 David Gibson <hermes@gibson.dropbear.id.au>
> orinoco.c 0.08 (David Gibson <hermes@gibson.dropbear.id.au> and others)
> orinoco_cs.c 0.08 (David Gibson <hermes@gibson.dropbear.id.au> and others)
> eth1: Station identity 001f:0001:0004:0034
> eth1: Looks like a Lucent/Agere firmware version 4.52
> eth1: Ad-hoc demo mode supported.
> eth1: WEP supported, "128"-bit key.
> eth1: MAC address 00:60:1D:F1:04:67
> eth1: Station name "HERMES I"
> eth1: Allowed channels mask: 0x000007ff
> eth1: ready
> eth1: index 0x01: Vcc 5.0, irq 22, io 0x0100-0x013f
>
>
> If you need any more info, just ask,
>
> --
> Josh Huber
>
>
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2002-01-19 1:52 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-01-18 2:38 orinoco_cs on linuxppc_2_4/linux-2.4-benh Josh Huber
2002-01-19 1:52 ` John & Trudy Phillips
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).