Hello,

I have an AMCC 405gp board on which runs u-boot. I try to boot the Linux Kernel via network but can not. I download uImage using DHCPD/TFTP. Here is the  minicom console output:


Type "run flash_nfs" to mount root filesystem over NFS

Hit any key to stop autoboot:  0
ENET Speed is 100 Mbps - FULL duplex connection (EMAC0)
Using ppc_4xx_eth0 device
TFTP from server 192.168.1.210; our IP address is 192.168.1.220
Filename 'uImage'.
Load address: 0x200000
Loading: #################################################################
         ###############
done
Bytes transferred = 1167936 (11d240 hex)
## Booting image at 00200000 ...
   Image Name:   Linux-2.6.25-rc7-00000-ga1ba6f0
   Created:      2008-04-07  12:32:44 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    1167872 Bytes =  1.1 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK


Here the console is frozen. It's the point where u-boot ends up and the kernel code starts. I think I have a mistake in addressing. I don't have sufficient knowledge about uImage format and the kernel compilation process. I followed the steps through the ELDK documantation from DENX software for cross-compiling the linux kernel as below:    

      bash$ make mrproper
      bash$ make ARCH=ppc CROSS_COMPILE=ppc_4xx- walnut_defconfig
      bash$ make ARCH=ppc CROSS_COMPILE=ppc_4xx- uImage

Could anyone help me solving the boot problem?