From mboxrd@z Thu Jan 1 00:00:00 1970 Content-Type: text/plain; charset="iso-8859-1" From: Rakesh jagota Reply-To: j.rakesh@gdatech.co.in To: Chris Zimman Subject: Re: Problem with kernel loading in PPC IBM405 based board Date: Fri, 7 Nov 2003 09:06:34 +0530 Cc: linuxppc-embedded@lists.linuxppc.org References: <20030611151322.GA9573@dingdong.cryptoapps.com> In-Reply-To: <20030611151322.GA9573@dingdong.cryptoapps.com> MIME-Version: 1.0 Message-ID: Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: Hi all, I am using openBios code, but i m not able to load the zImage.treeboot using tftp or serial port. I am directly loading the zImage.treeboot using JTAG (RISCWATCH). But I am not able to find out the exact loaction where we should load the image and then from where should be start running the kernel. I have seen the stext loaction (0xc0000000). Can you guide me exactly where should I load this image. Thanks & Regards, Rakesh On Wednesday 11 June 2003 08:43 pm, Chris Zimman wrote: > On Thu, Nov 06, 2003 at 08:05:59PM +0530, Rakesh jagota wrote: > > Hi all, > > I am working on PPC IBM 405 based processor board. I have kernel from > > "montavista" 2.4.17-mv121 version. I have tried to put the vmlinux image > > in the "SDRAM" after doing the all initialization (in boot level). > > > > We are loading the vmlinux in SDRAM at 0x00020000. I am not able to see > > any debug message on the serial port. I am not sure about the kernel jump > > location. Is there any way to find out the exact location to load the > > kernel and jump to proper location. > > You can't just boot vmlinux directly -- depending on which boot monitor > you're using (eg. OSOpen, PPC/UBoot) you need to be using a different > kernel image. If you're using OSOpen, you need zImage.treeboot. If you're > using PPCBoot/UBoot, you need pImage. > > --Chris ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/