* Not able to see any output if kernel module loaded for the first time
@ 2009-02-13 10:37 Vijay Nikam
0 siblings, 0 replies; only message in thread
From: Vijay Nikam @ 2009-02-13 10:37 UTC (permalink / raw)
To: linuxppc-dev
Hello All,
I am facing perhaps some strange kind of problem. I have mpc8313erdb
eval board and wrote the GPIO driver, the driver is just making the
assigned GPIO[3] pin high and low.
If I load this module first time after bootup or if I make some change
in the code and compile and load the module, then I am not able to see
any output on the scope but if I load it again then I will be able to
see the output on the scopt that GPIO[3] pin has became high and low.
Later if I removed the kernel module and load it again then also I am
able to see the output on the scope, till I do the reboot or power-off
and on.
Could anyone let me know why this happening ... thanks ...
Kindly please acknowledge ... thank you ...
Kind Regards,
Vijay Nikam
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2009-02-13 10:37 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2009-02-13 10:37 Not able to see any output if kernel module loaded for the first time Vijay Nikam
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).