BDI2000 not processing init list

BDI2000 not processing init list

[Lei Sun]

Hi all:
   I got BDI2000 today, tring to use to to debug my MMU problem. But
after I hooked it up and issue "reset", the following messages are
printed out:

BDI>reset
- BDI asserts HRESET
- Reset JTAG controller passed
- Bypass check: 0x00000001 => 0x00000001
- JTAG exists check passed
- COP status is 0x01
- Check running state passed
- BDI scans COP freeze command
- BDI removes HRESET
- Target PVR is 0x80822013
- Target SVR is 0x00000000
- COP status is 0x05
- Check stopped state passed
- Check LSRL length passed
- BDI sets breakpoint at 0xFFF00100
- BDI resumes program execution
- Waiting for target stop passed

It didn't process the init list, the IMMR still shows the default
value, instead of the one specified in init list.  The weird thing is
, if it didn't process init list, it should keep resetting because of
the watch dog timmer, I didn't see that happen as well.

My target is mpc8270, the BDI firmware version is 1.24 logic 1.05

Any one had the similar experience ?

Thanks
lei

Re: BDI2000 not processing init list

[Wolfgang Denk]

In message <f9a7e7a80611191321r291964cfh653a88714b3b0267@mail.gmail.com> you wrote:
>
>    I got BDI2000 today, tring to use to to debug my MMU problem. But
> after I hooked it up and issue "reset", the following messages are
> printed out:

Please RTFM, then check your BDI config file for the setting of the
STARTUP parameter, and/or try "reset halt".

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Overdrawn?  But I still have checks left!