[PATCH v3][POWERPC] document ipic level/sense info

[PATCH v3][POWERPC] document ipic level/sense info

[Stuart Yoder]

document level/sense encoding info for IPIC 
interrupt controllers

Signed-off-by: Stuart Yoder <stuart.yoder@freescale.com>
---
 Documentation/powerpc/booting-without-of.txt |   19 ++++++++++++++++++-
 1 files changed, 18 insertions(+), 1 deletions(-)

diff --git a/Documentation/powerpc/booting-without-of.txt b/Documentation/powerpc/booting-without-of.txt
index c169299..e7a465c 100644
--- a/Documentation/powerpc/booting-without-of.txt
+++ b/Documentation/powerpc/booting-without-of.txt
@@ -50,13 +50,14 @@ Table of Contents
       g) Freescale SOC SEC Security Engines
       h) Board Control and Status (BCSR)
       i) Freescale QUICC Engine module (QE)
-      g) Flash chip nodes
+      j) Flash chip nodes
 
   VII - Specifying interrupt information for devices
     1) interrupts property
     2) interrupt-parent property
     3) OpenPIC Interrupt Controllers
     4) ISA Interrupt Controllers
+    5) IPIC Interrupt Controllers
 
   Appendix A - Sample SOC node for MPC8540
 
@@ -1878,6 +1879,22 @@ encodings listed below:
 	2 =  high to low edge sensitive type enabled
 	3 =  low to high edge sensitive type enabled
 
+5) Freescale IPIC Interrupt Controllers
+---------------------------------------
+
+IPIC interrupt controllers are specific to Freescale 83xx
+SOCs.  Two cells are required to encode interrupt information.
+The first cell defines the interrupt number.  The second cell
+defines the sense and level information.
+
+Sense and level information follows the Linux convention
+(specified in include/linux/interrupt.h) and should be encoded
+as follows:
+
+	2 =  high to low edge sense type enabled
+	8 =  active low level sense type enabled
+
+Note: other level/sense types (0,1,4, etc) are not supported.
 
 Appendix A - Sample SOC node for MPC8540
 ========================================
-- 
1.5.0.3

Re: [PATCH v3][POWERPC] document ipic level/sense info

[Grant Likely]

On 7/10/07, Stuart Yoder <b08248@freescale.com> wrote:
> document level/sense encoding info for IPIC
> interrupt controllers
>
> Signed-off-by: Stuart Yoder <stuart.yoder@freescale.com>
> ---
> +       2 =  high to low edge sense type enabled
> +       8 =  active low level sense type enabled
> +
> +Note: other level/sense types (0,1,4, etc) are not supported.

Perfect!  :-)

Acked-by: Grant Likely <grant.likely@secretlab.ca>


-- 
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.
grant.likely@secretlab.ca
(403) 399-0195