Re: Oops with TQM5200 on TQM5200

["Grant Likely" <grant.likely@secretlab.ca>]

Paul, my git server is down at the moment.  Can you please pick this
one up for .25?  It is needed to boot the tqm5200 board.

Acked-by: Grant Likely <grant.likely@secretlab.ca>

Cheers,
g.

On Thu, Mar 20, 2008 at 9:24 AM, Anatolij Gustschin <agust@denx.de> wrote:
> Hello Wolfgang,
>
>
>  Wolfgang Grandegger wrote:
>
>  > I just tried Linux 2.6.25-rc6 on my TQM5200 module and got the attached
>  > oops. Are there any known patches fixing the problems?
>
>  try the patch below for tqm5200.dts, rebuild dtb and boot
>  again. Not sure if it works for Linux 2.6.25-rc6, but for
>  2.6.25-rc3 it does.
>
>  Anatolij
>  --
>   diff --git a/arch/powerpc/boot/dts/tqm5200.dts b/arch/powerpc/boot/dts/tqm5200.dts
>  index c86464f..7c23bb3 100644
>  --- a/arch/powerpc/boot/dts/tqm5200.dts
>  +++ b/arch/powerpc/boot/dts/tqm5200.dts
>  @@ -83,6 +83,7 @@
>                 };
>
>                 dma-controller@1200 {
>  +                       device_type = "dma-controller";
>                         compatible = "fsl,mpc5200-bestcomm";
>                         reg = <1200 80>;
>                         interrupts = <3 0 0  3 1 0  3 2 0  3 3 0
>  @@ -127,10 +128,25 @@
>                 ethernet@3000 {
>                         device_type = "network";
>                         compatible = "fsl,mpc5200-fec";
>  -                       reg = <3000 800>;
>  +                       reg = <3000 400>;
>                         local-mac-address = [ 00 00 00 00 00 00 ];
>                         interrupts = <2 5 0>;
>                         interrupt-parent = <&mpc5200_pic>;
>  +                       phy-handle = <&phy0>;
>  +               };
>  +
>  +               mdio@3000 {
>  +                       #address-cells = <1>;
>  +                       #size-cells = <0>;
>  +                       compatible = "fsl,mpc5200b-mdio";
>  +                       reg = <3000 400>;       // fec range, since we need to setup fec interrupts
>  +                       interrupts = <2 5 0>;   // these are for "mii command finished", not link changes & co.
>  +                       interrupt-parent = <&mpc5200_pic>;
>  +
>  +                       phy0:ethernet-phy@0 {
>  +                               device_type = "ethernet-phy";
>  +                               reg = <0>;
>  +                       };
>                 };
>
>                 ata@3a00 {
>  _______________________________________________
>  Linuxppc-dev mailing list
>  Linuxppc-dev@ozlabs.org
>  https://ozlabs.org/mailman/listinfo/linuxppc-dev
>



-- 
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.