From mboxrd@z Thu Jan 1 00:00:00 1970 Message-Id: Date: Tue, 23 Oct 2001 12:00:50 +1100 From: "Jeremy Rosen" To: Subject: RE: Problem using FEC on a860T Mime-Version: 1.0 Content-Type: text/plain; charset=US-ASCII Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: well, actually the patch worked only partially... the driver compiles, and registers properly, but doesn't seem to handle RPC correctly. I have the following message : when both fec and normal CPM ENET are compiled, RPC: sendmsg returned error 101 portmap: RPC call returned error 101 Root-NFS: Unable to get mountd port number from server, using default then a second atempt on the default port, with the same error. I have captured no packets on any of the interfaces. when I compile only with fec ( no CPM ENET ) it blocks at Looking up port of RPC 100003/2 on 172.16.0.1 I still can't capture any packets, the feth enable led isn't lit, and the collision and Tx leds of the board FOR THE CPM are blinking continuously... after a couple of seconds, the kernel starts scrolling eth0: tx queue full!. did I do something wrong ??? thx Jeremy ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/