[Marcel Weber <mmweber@ncpro.com>] re:Adaptec AIC7xxx version 6.08BETA release

[Marcel Weber <mmweber@ncpro.com>] re:Adaptec AIC7xxx version 6.08BETA release

[Marcel Weber]

    SuSE Linux 7.0, Kernel 2.4.0

    Adaptec 3950U2
    Adaptec 2940


    Although the kernel is complaining about the following things:

    kernel: scsi0: PCI error Interrupt at seqaddr= 0x4e
    kernel: scsi0: Data Parity Error Detected during address or write
    data phase
    ...

    This is compared to the original drivers already a incredible
    change: Those freezed my system after some time (something that did
    not happen before I upgraded from a K6-2 to a K6-2+: Apparently the
    old driver is working with loops or something)

    Continue like this!

    Marcel






    
    ____________________________________________________________________

    Marcel Weber 
    mmweber@ncpro.com 
    http://www.ncpro.com 



    Made and sent with Linux 

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/

Re: [Marcel Weber <mmweber@ncpro.com>] re:Adaptec AIC7xxx version 6.08BETA release

[Roger Larsson]

On Friday 12 January 2001 10:33, Marcel Weber wrote:
>     SuSE Linux 7.0, Kernel 2.4.0
>
>     Adaptec 3950U2
>     Adaptec 2940
>
>
>     Although the kernel is complaining about the following things:
>
>     kernel: scsi0: PCI error Interrupt at seqaddr= 0x4e
>     kernel: scsi0: Data Parity Error Detected during address or write
>     data phase
>     ...
>
>     This is compared to the original drivers already a incredible
>     change: Those freezed my system after some time (something that did
>     not happen before I upgraded from a K6-2 to a K6-2+: Apparently the
>     old driver is working with loops or something)
>

Hmm.. I start wondering if this is what I see too..
Both 2.2.18 and 2.4.0 hangs for some reason that I have not been able to 
trace down - Saturday I tried to remove all PCI cards but my 3dfx and AIC7xxx

  00:0f.0 SCSI storage controller: Adaptec AHA-7850 (rev 01) 

Has some driver been ported between 2.2 and 2.4 series recently ?
I have not seen this problem before...

I will try the new driver too...

/RogerL
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/