2.4.8, USB storage, and FAT12

[Damon Gunther <guntherd@home.com>]

Hi,

I just updated to 2.4.8 and I can no longer access the memory stick in my
Sony DSC-S75 camera via the USB camera connection.  This worked in
2.4.7 with the same config file.

The problem comes when I try and mount the SCSI emulated disk.  It gives me
the error:

jonx:~# mount -t vfat /dev/sda1 /camera
mount: /dev/sda1 is not a valid block device

If I do an fdisk to check the partition information:

jonx:~# fdisk /dev/sda

Command (m for help): p

Disk /dev/sda: 8 heads, 16 sectors, 991 cylinders
Units = cylinders of 128 * 512 bytes

   Device Boot    Start       End    Blocks   Id  System
/dev/sda1   *         1       990     63340+   1  FAT12

I noticed in the CHANGELOG that USB and FAT updates were made, so I don't
know which one of them is causing the problem.  I was using a modified entry
in unusual_devs.h to see the camera in 2.4.7.  This entry made it into 2.4.8.

I have vfat built as a module and I can mount my Windows partitions just fine.

Here is some dmesg output for more information:

hub.c: USB new device connect on bus1/2/1, assigned device number 5
usb.c: USB device 5 (vend/prod 0x54c/0x10) is not claimed by any active
driver.
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
  Vendor: Sony      Model: Sony DSC          Rev: 3.22
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 126848 512-byte hdwr sectors (65 MB)
sda: Write Protect is off
 sda: unknown partition table
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 5
USB Mass Storage support registered.

Please CC: me with your replies/help as I am not on the mailing list.

Thanks,

Damon

-------------------------------------------------------