From: "Tanya Brokhman" <tlinder@codeaurora.org>
To: <balbi@ti.com>
Cc: "'Alan Stern'" <stern@rowland.harvard.edu>,
"'Sarah Sharp'" <sarah.a.sharp@linux.intel.com>, <greg@kroah.com>,
<linux-usb@vger.kernel.org>, <linux-arm-msm@vger.kernel.org>,
<ablay@codeaurora.org>,
"'open list'" <linux-kernel@vger.kernel.org>
Subject: RE: [PATCH v12 7/8] usb: Adding SuperSpeed support to dummy_hcd
Date: Wed, 25 May 2011 12:26:08 +0300 [thread overview]
Message-ID: <015801cc1abd$ca534e20$5ef9ea60$@org> (raw)
In-Reply-To: <20110525092124.GI14556@legolas.emea.dhcp.ti.com>
> > As I mentioned, updating all of the gadget drivers will take a long
> > time and I don't fill confident enough doing since I'm not familiar
> > with all of them and don't have the ability to test each of them
> > properly. I can add SS descriptors to f_mass_storage, g_zero if it
> > helps and of course f_uasp already has them.
> > I'm a bit confused by this actually... We've been discussing this
> > patch series for quite a while now and I got the impression that
> > except for some minor comments you were all for excepting this. Was I
> > wrong or am I misunderstanding the above?
> > In any case, I don't feel that adding SS support for the Gadget
> > framework should be delayed until all gadget drivers add SS
> > descriptors because this patch series will give the developers the
> > ability to test these gadget drivers at SS. Also, several developers
> > addressed me offline with questions on this series so I know people
> > are using it in their work. And of course we do :)
>
> just remove the hunk which changes composite.c speed field and it
> should all be ok :-)
>
But that's why we added the feature flag. Isn't leaving it FALSE the same as
removing the part that updates gadget speed? It is protected with #ifdef.
Best regards,
Tanya Brokhman
Consultant for Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum
next prev parent reply other threads:[~2011-05-25 9:24 UTC|newest]
Thread overview: 59+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <1306132882-9668-1-git-send-email-tlinder@codeaurora.org>
2011-05-23 6:41 ` [PATCH/RESEND v12 1/8] usb: Add usb_endpoint_descriptor to be part of the struct usb_ep Tatyana Brokhman
2011-05-23 6:41 ` [PATCH v12 2/8] usb: Configure endpoint according to gadget speed Tatyana Brokhman
2011-05-23 6:41 ` [PATCH/RESEND v12 3/8] usb: Modify existing gadget drivers to use config_ep_by_speed() instead of ep_choose Tatyana Brokhman
2011-05-23 6:41 ` [PATCH v12 4/8] usb:gadget: Add SuperSpeed support to the Gadget Framework Tatyana Brokhman
2011-05-23 12:31 ` Sebastian Andrzej Siewior
2011-05-23 22:18 ` Mike Frysinger
2011-05-24 5:10 ` Tanya Brokhman
2011-05-24 5:14 ` Mike Frysinger
2011-05-24 5:37 ` Tanya Brokhman
2011-05-24 17:12 ` Mike Frysinger
2011-05-23 6:41 ` [PATCH/RESEND v12 5/8] usb: Add streams support to the gadget framework Tatyana Brokhman
2011-05-23 6:41 ` [PATCH v12 6/8] usb:dummy_hcd: use the shared_hcd infrastructure Tatyana Brokhman
2011-05-23 6:41 ` [PATCH v12 7/8] usb: Adding SuperSpeed support to dummy_hcd Tatyana Brokhman
2011-05-23 7:05 ` Felipe Balbi
2011-05-23 7:20 ` Tanya Brokhman
2011-05-23 7:21 ` Felipe Balbi
2011-05-23 8:18 ` Tanya Brokhman
2011-05-23 8:32 ` Felipe Balbi
2011-05-23 9:16 ` Tanya Brokhman
2011-05-23 14:22 ` Alan Stern
2011-05-23 16:08 ` Sarah Sharp
2011-05-23 16:28 ` Alan Stern
2011-05-23 21:06 ` Felipe Balbi
2011-05-23 21:21 ` Alan Stern
2011-05-24 5:53 ` Tanya Brokhman
2011-05-24 10:18 ` Felipe Balbi
2011-05-24 10:31 ` Tanya Brokhman
2011-05-24 10:33 ` Felipe Balbi
2011-05-24 10:43 ` Tanya Brokhman
2011-05-24 14:20 ` Alan Stern
2011-05-25 4:46 ` Tanya Brokhman
2011-05-25 9:21 ` Felipe Balbi
2011-05-25 9:26 ` Tanya Brokhman [this message]
2011-05-25 9:27 ` Felipe Balbi
2011-05-25 9:43 ` Tanya Brokhman
2011-05-25 9:49 ` Felipe Balbi
2011-05-25 10:03 ` Tanya Brokhman
2011-05-25 10:29 ` Felipe Balbi
2011-05-25 10:52 ` Tanya Brokhman
2011-05-25 11:23 ` Felipe Balbi
2011-05-25 11:33 ` Tanya Brokhman
2011-05-25 12:42 ` Felipe Balbi
2011-05-25 14:23 ` Alan Stern
2011-05-25 14:39 ` Alan Stern
2011-05-28 11:05 ` Tanya Brokhman
2011-05-28 14:15 ` Alan Stern
2011-06-07 10:33 ` Felipe Balbi
2011-05-25 17:07 ` Brokhman Tatyana
2011-05-25 17:29 ` Alan Stern
2011-05-25 18:13 ` Brokhman Tatyana
2011-05-25 18:59 ` Alan Stern
2011-05-26 6:51 ` Tanya Brokhman
2011-05-26 14:31 ` Alan Stern
2011-05-26 16:15 ` Brokhman Tatyana
2011-05-25 9:20 ` Felipe Balbi
2011-05-23 15:55 ` Sarah Sharp
2011-05-23 14:20 ` Alan Stern
2011-05-23 14:18 ` Alan Stern
2011-05-23 6:41 ` [PATCH v12 8/8] usb:gadget: coding style fixes Tatyana Brokhman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to='015801cc1abd$ca534e20$5ef9ea60$@org' \
--to=tlinder@codeaurora.org \
--cc=ablay@codeaurora.org \
--cc=balbi@ti.com \
--cc=greg@kroah.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=sarah.a.sharp@linux.intel.com \
--cc=stern@rowland.harvard.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox